Your cart is empty.
Your cart is empty.Energy Suspension 9.5165R 1-1/4" Greasable Sway Bar Set
SDJ50504
Reviewed in the United States on March 13, 2024
Good price, perfect fit & looks great.
Mary Hanna
Reviewed in the United States on August 8, 2021
Perfect product for my car
Mark
Reviewed in the United States on March 21, 2021
Everything was great
Darrell Slifka
Reviewed in the United States on September 30, 2017
Work nice, look nice!
apb
Reviewed in the United States on July 17, 2017
Fit my 2007 Speed3's James Barone Tru-Torsion.125 Adjustable Rear Sway Bar. Seems like good quality.
Ben
Reviewed in the United States on October 28, 2017
I purchased these bushings for my 2004 dodge ram 1500 because they were the only greasable ones available. They were trash. With new end links, upper and lower control arms with bushings and ball joints, new cv axes, new wheel hubs, tie rod ends, and rack and pinion I still had a front end clunk. I decided to replace these with a set of moog bushings in the stock brackets (which are leagues more durable than these strap-steel pieces of scrap) and modify it to accept a grease zerk. The moog bushings are a little over a cm in the center while these are roughly 1 mm. I think the issue is that they are trying to use the same brackets for every diameter of sway bar bushing that they sell. So as the diameter increases the bushing must get thinner and thinner to fit in the strap. These brackets also don't have a hole for the bolt, they have a slot. So unless you torque them to 150 ft/lbs there's a good chance it will just scoot back and forth in the slot.
Scott
Reviewed in the United States on June 18, 2016
Overall, I like these bushings. One ongoing issue, but it is small... These come with caps over the zerks; the cap on one of mine came ripped from the loop that holds it on. I did initially have a problem with one of the brackets. It seems that I didn't tighten the bolt holding it to the frame enough. This left a small gap and a space where the sway bar could bent the bracket away from the frame. I fixed it in a vice and it's been fine since. That last issue was my fault, but I believe the stiffness of the brackets provided here does not match the OEM bracket stiffness. The OEM piece would not have bent.
Alex R.
Reviewed in the United States on October 7, 2015
Did what I needed it to.
Recommended Products
