Your cart is empty.
Your cart is empty.Product Description
- Tracer AN series controller, based on multiphase synchronous rectification technology (MSRT) and advanced MPPT control algorithm, with dual-core processor architecture and common negative design, has the features of high response speed, high reliability, and high industrial standard.
- MSRT can sure very high conversion efficiency in any charge power, which sharply improves the energy efficiency of solar system; Advanced MPPT control algorithm minimize the maximum power point loss rate and loss time, to ensure the tracking efficiency, corresponding speed as well as high conversion efficiency under high or low power, so that in any situation, Tracer AN products can rapidly track the maximum power point(MPP) of PV array to obtain the maximum energy of the panel.
- With the adaptive three-stage charging mode based on digital control circuit, Tracer AN series controllers can effectively prolong the life-cycle of battery and significantly improve the system performance. The load, utility or generator auto-control relays make it easy to compose the hybrid power system.
- It support up to 8 charging in parallel to expand system and meet with different monitoring requirements, so that can be widely used for various applications, e.g. solar RV, household system and field monitoring, etc.
Features:
- 12V/24V/36V/48VDC Auto
- High quality & low failure rate components of ST and Infineon to ensure the product’s life
- The accuracy of the recognition and tracking at the highest point of multiple-peaks MPP
- Auto control system to limit the charging power & current go over the rated value
- Battery temperature compensation function, Real-time energy recording and statistical function, Automatic over-temperature power reduction function
- Load relay control external load switch signal to realize diversified load work modes
- All-around electronic protections, including overcharging, over discharging, and PV reverse polarity protection, effectively ensure the safer and more reliable operation of the solar system for a longer service time.
The isolated RS485 interface with standard MODBUS communication protocol and 5V power supply makes it easy for customer to expand the application
Ensure compatibility with any negative ground system, which is the standard and most conventional way of grounding
Made of aluminum alloy material good heat dissipation
Battery Type:
- Lead-acid batteries
- Lithium-ion batteries
NOTICE
- The controller connection sequence is Battery--Load--Solar Panel, and discounect the system in the reverse order Solar Panel--Load--Battery
- Browse interface: when no operation, the interface will be automatic cycle, but the follow two interfaces not be display
Package List:
- 1 x Tracer 10415AN Solar Charge Controller
- 1 x User Manual
THOMAS EBERT
Reviewed in the United States on March 26, 2025
Only 4 stars because unit says up to 800 watts of panels however error coded until I removed 2 100watt panels so would only take 600 watts. However this system keeps my off grid power up to what I need. Quality material.
Customer
Reviewed in the United States on March 10, 2025
Very sturdy charge contoller, huge heat sink with a fan less operation. Supports Lithium batteries too !
Customer
Reviewed in Canada on February 3, 2025
this is the second one I purchased for cabins off grid in the bush. Works like a charm
Serge Theriault
Reviewed in Canada on January 15, 2025
Utilisé avec mes 2 panneaux 320 w et mes 2 batteries LIFEPO4 280 ah
Jacques
Reviewed in Canada on July 2, 2024
Très bonne qualité,je suis très satisfait ,très bonne performance ,mes des foix la charge arrête à 13.9 au lieu de 14.4 je suis obligé de faire un reset pour tout redevienne normal et le problème revient après 2 jours .
Overstreet
Reviewed in the United States on January 7, 2024
Works as described with a 12v lifep04 system.
Sherwood Layton
Reviewed in Canada on April 19, 2024
I have 4 different charge controllers. This one, by far, is the best one I've got. It starts charging at .3 amps, the next best one I have is .7 amps. I am extremely happy with this unit and would recommend it to anyone starting or upgrading.I have this unit hooked up to 8-100-watt panels, and at its highest output, I saw 57 amps. I was expecting maybe 48 amps.It works wonderfully well even on cloudy days, just not in the 40-50 amp range.A key point to remember; make sure you have enough battery capacity to handle the amount of energy you will generate.This is April, and I have already had days where this unit has produced over 4 KW in a single day.And I'm in Canada.
younis-24
Reviewed in Saudi Arabia on July 19, 2023
يجب اخذ بالاعتبار مقاس المنظم ، خاصه عند التركيب في الكرفان
T. K.
Reviewed in the United States on May 18, 2023
Needed to add an MPPT controller for additional solar panels to provide more power to our 24v battery bank. The installation was simple and straightforward - cables in from the panels (disconnected) and a set of cables to the batteries, including an ANL fuse block. MPPT detected the lithium batteries just fine and when the solar panels were switched on, power was being generated with no issue. Running solid for several weeks now. Will note also that their support is quite engaged - checking on satisfaction and any suggestions.
James C.
Reviewed in the United States on September 23, 2022
Used as a replacement for the exact same model. First one lasted a little over a year. The screen just stopped working and the remote display would not communicate with the controller. This replacement after about the same amount of time done the same thing. I guess its OK if you need it for 1 year or so. JUNK
RLohengrin
Reviewed in the United States on June 28, 2022
The Tracer Eveper 6415 AN arrived quickly and well packaged. I was surprised by how large it is and it weights 15 pounds. The only complaint I have is that it should be stated that the unit will be useless at it is for Lifep04 batteries unless you have someway to edit the parameters with an external device as a phone or computer and that also requires the addition of the MT50, ebox WiFi interface or connection to a computer and installation of software. I think that a device this size should come with an easier way to set basic parameters for a Lifep04 battery.So I could not use the Controller until the ebook wifi interface arrived. Getting the interface to work with the phone app was another frustrating experience as it would not communicate with the Controller and now I had e question of which element on the chain was having problems, the controller, the ethernet cable, the ebox or the app!I tried two new Android phones and it would not work. Then I used my phone browser to connect to the ebox using IP 11.11.11.254 login admin and also admin for password. The screen showed connection to the ebox but nothing from the Controller. At least I was able to know that the ebox, cable and connection to the Controller was good. I then tried an old phone I purchased years ago at Dollar General and to my surprise the ZTE old phone did the trick! So I would conclude that the problem is on the software or app side.Now that I have the whole system figured out I am very pleased with the new controller but would advise de saler and company to make it clear to the customer that if using Lifep04 an MT50 is required for easy editing and selecting battery type.
Daniel Kurek
Reviewed in the United States on November 1, 2022
I hooked this epever charge controller to my four 24v renogy 320w panels in 2S1P configuration for 1280 Watts to charge my 2 lifepo4 300ah batteries in parallel for 600ah bank and so far works great! Customer service was great to work with and helpful advising panel configuration.
Fishingmania
Reviewed in the United States on June 29, 2020
It looks like a well made unit and is performing well at this early stage, I had a couple of questions about the unit and got a quick accurate response from their tech department. It boosts the power by 15 to 20% but of course that number will vary depending on your system.
Recommended Products