Your cart is empty.
Your cart is empty.
Warm tips:
Phase filering is not available for Flipsky ESC75100 and 75200!
Please turn off the phase filter function and choose "false" in vesc_tool when use firmware version on or above 5.3 (VESC_TOOL 3.01). Without turning off the phase filter will result in esc damage. Please do not restore the default parameters when using the wizard interface.
Spec:
- Voltage:14-84V( safe for 3-20S)
- Continuous Current : 50V/350A,75V/250A
- Max Current :800A
- Supported sensors: ABI, HALL, AS5047,AS5048A
- EPRM:150000
- Size:200*94.6*50mm((Including the height of water pipes and electrolytic capacitors)
Feature:
- Regenerative braking
- The CPU adopts the 32F405 with the main frequency of 168MHz and the Cortex-M4 architecture with DSP function;
- Sensored or sensorless operation + hybrid mode
- Configurable RPM-, current-, voltage- and power limits
- Input source: PPM, ADC, NRF,UART,PAS
- Communication ports: USB, CAN, UART,SPI,IIC
- Throttle curve and ramping for all input sources
- Seamless 4-quadrant operation
- Motor revolution, ampere hour, watt hour counting
- Real-time data analysis and readout through the communication port.
- Adjustable protection against:
- Low input voltage
- High input voltage
- High motor current
- High input current
- High regenerative braking current (separate limits for the motor and the input)
- High RPM (separate limits for each direction)
- Digital VCC and analog VCC are produced by different voltage regulators respectively to make the system AD conversion more accurate
- Motor wire: 8AWG
- Power cable: 8AWG
- Waterproof level(with water cooling enclosure):IP67
K.R
Reviewed in the United States on March 2, 2025
Controller never worked
Christopher C.
Reviewed in the United States on June 4, 2024
This is a great product. I was able to diagnose existing issues in my 12s and 16s setup as well as review after use how things went. This allowed meaningful implementation of limits to keep within appropriate voltage and current ranges among other settings rather than just guess work. The setup was simple and there's plenty of guidance on the web through the vesc pages. The new firmware is a must. Very smooth pick up from rest and high fidelity speed control with my 4 and 5 series sensorless motors. Only criticism is the max erpm could be a bit higher for high kV high pole count motors.
horst schohl
Reviewed in Germany on November 14, 2024
keine Gebrauchsanleitung vorhanden / Rechnung lässt sich nicht abrufen
Jessee Johnson
Reviewed in the United States on January 2, 2024
Very fast but the one i received had obviously been used. The plugs had been cut off and there was 2 plugs soldered on power wires and a set of ring terminals were crimped on to outputs. The hall sensor plug had been cut off and adc plug was cut off along with a few other wires that had been cut ☹️ i hooked it up sensorless for a quick test and it worked. I just hope all functions work correctly. I am building an efoil to pit this in and net ready for install yet. Was bummed that plugs were cut off.
Brandon F.
Reviewed in the United States on June 8, 2023
Has the ability to run 210A @84V. Definitely recommended as it's affordable, will require just a few knowledge to program and run the vesc.Edit: you shouldn't push these controllers to its limits, they will end up messing up mid-drive.
Recommended Products
