Your cart is empty.
Your cart is empty.Product Description
FEATURES
IP68 Waterproof
IP68 waterproof & shockproof & dustproof rate protect the LED Pods Lights from leaking under the water.
Rock Solid
6063 Die-cast aluminum housing can ensure the led flush pods mounting wide working temperature(-40°C~85°C).
Efficient Cooling
Relatively thin & dense, 9pcs aluminum alloy heat sinks maximize surface area for optimal cooling.
Easy Installation
With paper model brings innovative model, allowing you to easily cut shapes and protect lights from impact.
Put them on the front of your vehicle, go from just a speck of light in front to seeing the whole road side to side.
Mario Sellars
Reviewed in the United States on March 21, 2025
You will need to add 16-14 gauge wire to reach where ever you are hooking up to get power/ground. Not crazy bright but definitely a step up from factory tail lights as I’m using them for my reverse lights. Might add more of these on my rig for auxiliary lighting
Victor Perez
Reviewed in the United States on March 21, 2025
Great
J. C. Davis
Reviewed in the United States on April 20, 2022
I hate backing up my truck in the dark because I can't see behind very well on the stock reverse lamp. I installed these and it's like having headlights on the rear bumper. They fit flush, were fairly easy to install and are very bright. The wiring might be a challenge if you aren't familiar with the proper way to do that in a vehicle but it's manageable.
Richie
Reviewed in the United States on December 1, 2021
Somewhat easy to install, great light when backing up, but after about the sixth rain, one took on water and has constant moisture inside of the glass along with some of the lights inside going out. I have had these a few months and so far their waterproof story is a LIE‼️
65CrownV8
Reviewed in the United States on February 6, 2020
Installed for only 2 weeks and the mounting hardware is rusty. Recommend purchasing stainless hardware prior to installation and toss the provided hardware in the trash. Lights work as expected, hope they last a long time.
Customer
Reviewed in the United States on February 24, 2019
Exactly as described, and was an easy install. Had both original lights go out on me and wrote the company. They walked me through some steps and it did not work, so they sent me a whole new set. Very fast response times and very good communication. Affordable lights that look good and great customer service. A+
TruckTrader
Reviewed in the United States on October 16, 2019
I mounted these in the rear aftermarket bumper on a 2015 Jeep JK, they look nice like a factory product and I'm happy with the appearance. Brightness is just okay but decent value for the money. I like the flush mount but the difficulty of the install can vary greatly depending on where you're going to put them and the material you will need to cut through to make the required holes. I traced the supplied pattern onto my bumper then used a plasma cutter to freehand cut the holes needed through 1/4" steel which is not easy to do for the average garage installer. You could also make the holes by drilling the corners and cutting to connect the points but again this may be difficult for some to do freehand if you're dealing with a very thick material and not experienced. Total install with cutting, repainting and wiring took several hours
Skipper
Reviewed in the United States on November 12, 2018
The first thing I did was a bit of research and testing to verify I had the correct wire to tap into on my truck. After finally getting the courage up to cut holes in my back bumper, I installed these. They look and work great! Very bright. I’ve seen the other reviews that complain about moisture fogging inside these, but I haven’t had any problems so far. I even cleaned my truck with a pressure washer (NOT spraying directly on lights), and no issues.
Recommended Products