Your cart is empty.
Your cart is empty.No one does 8.8" gears better than Ford Racing...stronger and quieter! The 8.8" rear end has been the standard in performance since its introduction in the Mustang in 1986 and Ford Racing is the manufacturer of choice when it's time to hop-up your axle. Fits any Ford with an 8.8" rear end until 2014. Does not fit 2015+. Made in the United States at Ford's Sterling Axle Plant (competitors in this price range are primarily produced in China) OEM quality - our superior surface finish, hardening, and manufacturing consistency provide the strongest and quietest 8.8" gears in the market! These are the same units that have 100,000 mile warranties in our production cars. Higher quality gears means more satisfied customers! Race Proven - Ford Racing 8.8" gears are the choice of championship road racing and drag racing teams including Multimatic Motorsports and Kurgan Motorsports. When your plans call for an 8.8" gear, look for the only brand good enough to wear the Ford oval! Includes Ford pinion nut and Ford crush sleeve.
808
Reviewed in the United States on November 5, 2024
Worked great in my truck, wish I went with 4.10 though. Upgraded from 3.30 to 3.73. No noise or whining, super quiet
steve schwartz
Reviewed in the United States on June 22, 2022
2011 F150
Anthony
Reviewed in the United States on March 29, 2022
I've set up many gears in the past 40 years, but Ford Racing Gears are by far the easiest to set up and quietest gear sets made. Highly recommend this seller. Great product and service.
The Jackal
Reviewed in the United States on October 21, 2021
Very quiet gear, easy set up 3.73I had an expensive Motive gear set in my custom built 8.8 and I couldn't get it to run quiet no matter what. Set it up perfectly new bearings, shim kit, crush sleeve eliminatorSlow multiple short heat cycles changed fluid 2xChecked pattern and lash it was spot on.The Motive gear was just bad noise on excel and decel.So I went with the FORD Performance gear set and WOW what a difference! I used the same bearings so I know it wasn't a bearing causing an issue..The car is a dream to drive again with zero rear end noise.Ford gear in a Ford housing who would've thought...
Clarence Smock
Reviewed in the United States on April 2, 2021
Easy set up and big performance gain
Paul W.
Reviewed in the United States on June 24, 2017
Installed in the rear of a 2006 Mercury Grand Marquis. Just like the rumors said, the tolerances are so close to the factory parts that I didn't even need to change the shims - the backlash was perfect. Always verify though. Set includes a crush sleeve and a nut.
Dan
Reviewed in the United States on December 7, 2015
Received it in less than a week came as pictured. Happy customer 👍
VANCE O.
Reviewed in the United States on November 16, 2015
Wow what can I say works great
Recommended Products
$223.94
$ 93 .99 $93.99