Shopping Cart

Your cart is empty.

Your cart is empty.

Gates 24020 Vulco Straight Coolant Hose-3' Length, Inner Diameter 1 1/4'

Free shipping on orders over $29.99

$22.09

$ 9 .99 $9.99

In Stock

About this item

  • Heat-resistant cover
  • Cover marked in 1 in. increments to facilitate approximate cut lengths, allows “custom fit” installations
  • Meets SAE 20R1 Standard Wall Class D-2 requirements
  • Temperature Range: -40 Deg. F to +257 Deg. F (-40 Deg. C to +125 Deg. C)
  • Note: For a maintenance free connection, use PowerGrip SB clamps


Vulco Straight Coolant Hose is specially engineered for straight coolant or air connections in automotive, stationary engine, industrial and home applications.


Slinky dink
Reviewed in the United States on June 6, 2023
Great looking hose nice and thick.
Coach
Reviewed in the United States on July 7, 2022
Used in 1/3's lengths for a hitting tee. 2nd time replacing the hose after 20 years of use.
Jerry Whalin
Reviewed in the United States on June 14, 2022
Not wire reinforced, had to make small bend and it collapsed! Return was going to cost half as much as original cost , so I kept it. Before ordering this item be sure to check return policy!
Matthew J. Curran
Reviewed in the United States on November 26, 2018
This item was just the ticket for my 1994 Corolla w/1.6L motor (4afe). I was doing a timing belt/water pump and this hose is pretty easy to access once you've already removed what's required to do the belt/pump. It's also subjected to considerable heat and pressure, so should probably be replaced whenever convenient, especially since it's cheap and you get enough to do the job multiple times with this hose.Although you only need about a 3'' length of this tubing, don't be tempted to use normal heater hose. This hose is reinforced and can tolerate the high temperature (located right next to cylinder head, behind motor) and pressure (the bypass hose sees the highest pressure because it's right off of the pump) that this application sees.I'm glad that I decided to replace this hose, as the old one was a standard radiator hose that had swelled very considerably and looked ready to burst (not sure how long its been on, but at least 85k miles, since I've never changed it).Word of advice: Cut the tubing to length carefully. Since the hose is very stiff, you must have the length pretty precise, otherwise the water pump housing will not bolt up to the block correctly.
Ed B.
Reviewed in the United States on April 26, 2017
hoses are sized by inside diameter . The seller stated size to be 1.6 when inside diameter is actually 1 1/2"
Ron Elkins
Reviewed in the United States on May 6, 2016
👍
William T. Schreck
Reviewed in the United States on October 5, 2015
great product....
Customer
Reviewed in the United States on October 22, 2015
Arrived as stated only needed 3 inches of it though.