Your cart is empty.
Your cart is empty.michael j. kassarjian
Reviewed in the United States on May 25, 2025
All good
CONSUMER I
Reviewed in the United States on May 23, 2025
Works well!
D. prof Pad.
Reviewed in the United States on March 6, 2025
Easy to put on after you remove the old tether. Snaps right on. You just have to cut the old one off, impossible to remove otherwise.Dealership charges $190 to replace. DIY!!
GRB
Reviewed in the United States on January 30, 2025
Fit my 2017 V60 gas cap perfectly.
SocalI
Reviewed in the United States on February 22, 2024
Identical perfect for! I used an old ginsu knife to carefully and cautiously cut through most of the old ring. Trying not to accidentally damage the original cap. Then used a hammer to tap the ring off and it easily popped off without too much force. I worked slowly and carefully to not damage the actual OEM cap that I was going to keep. Then I just snapped this replacement cap ring right on to the cap in just a couple seconds. So easy. Perfect fit. Like new again. And now I don’t have to worry about losing my gas cap.
John R
Reviewed in the United States on November 21, 2024
Faster delivery than promised. Perfect fit can’t beat OEM parts. I recommend this dealer
Thomas J Guaraldo
Reviewed in the United States on December 28, 2023
Fits perfect on my 2009 Volvo S80 T6. Not that difficult to install. Pry the existing ring off with a small flat head screw driver. Pry off from the top side of fuel cap at the thinner end of the ring. To install the new tether ring, press down from both sides into the fuel cap groove from the larger end of ring toward the thinner end of the ring and the use a plier to press on smaller end of ring with minimum pressure to push the ring into the groove on the fuel cap. It took 5 minutes to replace.
Bruno Landry
Reviewed in Canada on October 5, 2020
Perfect fit
MarkLondon
Reviewed in the United States on July 29, 2017
I own a 2007 Volvo S40 T-5 Turbo and this does NOT work on my Volvo OEM gas cap...(It obviously works on other year Volvos based on the reviews though)I received the part very quickly but when I attempted to swap out this very simple and easy gas cap strap, I found that it was very different from the OEM gas cap strap.1) It has a hole where a nipple type piece of rubber fits into the flip out Gas door panel (See Pics)2) The ring is 4mm too small, so it doesn't rotate on the cap (I did use the trick that one reviewer suggested that was to put it in boiling water for awhile which did help get the ring onto the cap...but as I mentioned, it was way too tight so it doesn't rotate when you tighten up the cap after filling with gas.As I wasn't going to bother sending it back, I thought I could make do.So I went to my local auto part store and bought a plastic type rivet for $2.71 that is used to hold interior panels etc together. (See Pics)Here is what I did, (see Pics)I hope this helps with your purchase!Cheers, Mark
Recommended Products
