Your cart is empty.
Your cart is empty.Product Description
Package Including:
- 1x Eyebolt
- 1x Gimbal Bearing Puller
- 1x Engine Alignment Tool
- 1x Gimbal Bearing Installation Tool
Gimbal Bearing Puller/Remover & Bearing installer & Alignment Tool
High-quality materials:
- This puller alignment tool is all made of strong steel.
- Ensure the efficiency of work and save you time during maintenance.
- Nice Black Oxide finish on the puller.
- No rust, accurate tools，No more hassles of slide hammer jaws not grabbing & busted knuckles.
Fitment&Function:
- Fits for Mercruiser Alpha, for Alpha 1, for MR, for bravo's, for OMC cobra's and for Volvo.
- This tool set can easily remove/install Gimbal bearings and alignment tools for engine alignment.
Disassemble the bearing
Step 1:
Check the location for debris and simply clean it up,Place the product according to the picture.
Step 2:
Find a suitable wrench and Turn the wrench hard.
Step 3:
After the wrench is tightened, the product can be easily taken out, and the bearing will come out with the product.
Install the bearing
Step 1:
Use an electric drill to make a hole where you need it.
Step 2:
Fix the parts with small screws.
Step 3:
Put the bearing on the product and put it in the engine.
Step 4:
Hammer the bottom with a hammer to make the bearing enter the engine and fix it.
Ravi Gunn
Reviewed in the United States on June 27, 2024
Just what is needed to get the job done. Can not complete the job without it. I mean, maybe you could, but it would be very very difficult and would require a custom fabbed piece to do it
axlr8or
Reviewed in the United States on October 13, 2024
Gimbal extractor works. One of these guys needs to come down here and show me how the installer works. There is a driver for the bearing with pin but the driver rod itself has no hole like shown in the picture. How do you miss that?
Greg
Reviewed in the United States on April 16, 2024
This kit worked perfectly on my Alpha one mercury outdrive. I saw a lot of people mention that it was a hassle to drill the hole when you better have all this alignment stuff. I threw it in use my regular drill drill guide and then the second hole was lined up. Pulling Gimble be very easy. I did have to adjust it up at an angle because my bearing was sitting in their crooked and it came out the second time I made the adjustment to the angle. I would highly recommend this.
Recommended Products