Shopping Cart

Your cart is empty.

Your cart is empty.

Glixal ATMT1-079 GY6 49cc 50cc Scooter Carburetor Intake Manifold Inlet Pipe for 139QMB 139QMA Engine Moped ATV Go Kart (Single Vaccuum Port)

4.3 (8) Write Review
Free shipping on orders over $29.99

$6.99

$ 2 .99 $2.99

In Stock

About this item

  • Single Vaccuum Port Intake Manifold Pipe GY6 50cc-100cc 139QMB
  • Engine Mount Side Inner Diameter: 17mm
  • Bolt Hole Spacing: 45mm
  • Carburetor Mount Side Inner Diameter: 26mm
  • Includes: Intake Manifold and Clamp


1.New Products with High Quality
2.Replacement for GY6 50cc Intake Manifold Pipe
3.Glixal-Racing Team will supply parts for BAOTIAN, BASHAN, BENZHOU, CFMOTOR, CHARMING, DAYANG, DINLI, FUXIN, GEELY, GILERA, HANGLONG, HAOJIN, HAOJUE, HISUN, HONGZHOU, HUATIAN, JIAJUE, JIANSHE, JINLUN, JMSTAR, JONWAY, KAITONG, KEEWAY, KINROAD, KYMCO, LIFAN, LINGBEN, LINGTIAN, LINHAI, LINTEX, LONCIN, LONGJIA, MAWI, MEIDUO, MOTORRO, PIAGGIO, QINGQI, RHON, RIEJU, SACHS, SHINERAY, SKYGO, SUKIDA, TAOTAO, VESPA, VONROAD, WANGYE, WONJAN, XINGYUE, XINLING, XINTIAN, YIBEN, YINGANG, ZHONGYU, ZNEN, ZONGSHEN,ect


Joe Leonard
Reviewed in the United States on September 26, 2024
Worked very well
Mathew Wilson
Reviewed in the United States on September 18, 2024
Listing exactly as stated, fits 50cc mopeds with the 18mm carb(stock) Finnish was good I did have to clean 1 metal bur from the aluminum otherwise was fine and bolted right up. Clamp is factory quality and works as it should, 10/10 would recommend!
morris fogaren
Reviewed in the United States on September 10, 2024
Threw it in trash
Thomas Pauley
Reviewed in the United States on March 25, 2023
Was exactly as shown
Heather
Reviewed in the United States on September 20, 2021
It was exactly as described. Satisfied with my purchase.
Todd C Hower
Reviewed in the United States on March 21, 2020
Perfect fit. No issues
james field
Reviewed in the United States on October 17, 2020
Sturdy Rubber construction, comes complete with hardware and O-ring.
John Wohlwend
Reviewed in the United States on July 2, 2018
Standard qmb139 manifold with single vacuum port. Well made. Rubber is not brittle and head to manifold mating surface is evenly machined. It uses a rubber ring instead of a paper gasket. The ring is attached to the groove using an adhesive but it is not fuel proof so keep an eye out to make sure you don't lose the ring. I recommend leaving the manifold attached and tightened to the carburetor when removing the carburetor from the scooter by removing the manifold from the studs on the head as you don't want to strip the head of the screw on the clamp or stretch the rubber of the manifold and invite vacuum leaks. Never been dissapointed with a Glixal product.