Shopping Cart

Your cart is empty.

Your cart is empty.

GlowShift Black Triple Pillar Gauge Pod Compatible with Honda Civic 2 Door Coupe 2001-2005 - ABS Plastic - Mounts (3) 2-1/16' (52mm) Gauges to Vehicle's A-Pillar

Free shipping on orders over $29.99

$52.99

$ 26 .99 $26.99

In Stock
  • GlowShift Black Triple Pillar Gauge Pod is Custom Molded to Fit the 2001-2005 Honda Civic Coupe & Mounts 3 Aftermarket Automotive Gauges to the Vehicle's A-Pillar - Overlay Design Mounts Pod on Top of the Factory A-Pillar
  • Holds (3) 2-1/16" (52mm) Gauges - Compatible with GlowShift 7 Color Series, 10 Color Digital Series, Elite 10 Color Series & Tinted Series Gauges
  • Manufactured from High-Quality ABS Plastic - Designed to Protect Against Warping, Cracking & Color Fading
  • Includes Pillar Pod Mounting Hardware & Installation Instructions
  • GlowShift Guarantee with One Year Limited Warranty & Free Lifetime Technical Support


This Black Triple Gauge A-Pillar Pod is an aftermarket gauge pod that is specifically designed for your 2001-2005 Honda Civic Coupe, allowing you to mount three 2 1/16th inch (52mm) gauges for a completely custom look. This Civic triple A-pillar pod is manufactured from high quality ABS plastic that allows it to withstand cracking, fading, and warping. GlowShift’s 2001-2005 Honda Civic pod is paintable using ABS plastic paint, and is mounted to your factory A-pillar with the included screws. GlowShift includes mounting hardware, installation instructions, and a one year limited warranty with every A-pillar pod purchase.


justin whisner
Reviewed in the United States on April 2, 2022
Nice quality can’t wait to install it
David
Reviewed in the United States on January 31, 2019
worth it, it came with the screws to tap into the o one and is looking nice
DjRuki
Reviewed in the United States on August 24, 2014
Great
WhoMeYahYu
Reviewed in the United States on January 29, 2014
Aside from trimming off about 2mm on the upper most corner piece it's near perfect when installed. I recommend that before installing this product onto your factory pillar trim, either use a marker or marking pencil to draw a line on the bottom of the oem trim using the dashboard as a guide. Then remove the oem trim and apply this product onto the trim lining up the bottom edge of this piece with the line you drew on the oem trim. Then mark where you want to put the screws. They give you four screws with matching cover but it would've been helpful if they gave you six in my opinion. FYI: It comes in glossy black and the delivery service is legit.
Recommended Products