Your cart is empty.
Your cart is empty. This U/J has a 1.063" cap diameter. Please double check your current part's dimensions before ordering, as there may be two different driveshaft variations for your vehicle.
If you have a 1.188" cap diameter, please check out GMB# 210-0178 instead.
Great Lakes
Reviewed in the United States on May 25, 2025
Great price , but I had to grind down both sides to be able to slid it in to place .
Octavio correa
Reviewed in the United States on February 26, 2025
Ordene la partes tres crusetas para mi nissan xterra 2002 y no son estan mas grandes
DAVID V.
Reviewed in the United States on June 16, 2022
I was very impressed with the overall quality of this part. That is sold at a great price. I could see a big difference from the old U joints. That I removed in regard to quality. The U Joints fit well with no issues on install. I would Buy again .....
Alberto
Reviewed in the United States on September 19, 2021
I like that they were delivered on time and are easy to install
Peanut brained Bill
Reviewed in the United States on August 7, 2021
These have deeper cups than stock on my RAM 1500. Although that makes it a bit of a trick to remove them.
Customer
Reviewed in the United States on March 16, 2021
Ordered two for my 1996 F 150. I used the press from my Astro Pneumatic Tool 7865 Ball Joint Service kit. Pressed the old ones out, clean everything up, and pressed the new ones in. Took 2 hours.
joshua
Reviewed in the United States on October 11, 2020
This particular part number fits 2004 dodge ram 1500 5.7 liter!!!!Be aware that the uv joint does come with grease from factory but not enough so make sure you verify the grease type and add more of the same!!!!I installed it and immediately took it and beat the H ell out of it and so far so goodCan't beat it for the price!!!Recommend for a daily don't know towing!!
James H. Agans
Reviewed in the United States on May 6, 2016
Perfect fit on my 1994 F150 4.9 Liter Six, 2WD. Unscrew the grease fittings, pull off the bearing caps and stuff with grease before installation, this will keep the needles in place while you install caps on trunions. WHen you are finished installing (I use a couple of sockets, a big C-Clamp, and a ball peen hammer) reinstall grease fittings and grease. clean off excess grease, it attracts dirt. Sorry if I'm preaching to the choir. I recommend re balancing driveshaft, after all this.
Recommended Products
$32.99
$ 13 .99 $13.99
$31.78
$ 16 .99 $16.99