Your cart is empty.
Your cart is empty.GPM Replacement Parts for 1:10 KRATON 4S BLX / SENTON 3S BLX Upgrade Parts Aluminum Rear Gear Protection Motor Mount - 10Pc Set Red
The Harrison's
Reviewed in the United States on September 21, 2021
Added this to my 3s Vorteks. It does not have holes for the 18t stock pinion. I'm going to run the 20 in it and see how it goes. Mesh looked good on the 20t.
Samual Christopher Matthews
Reviewed in the United States on August 16, 2021
Rocky L. Dowell
Reviewed in the United States on July 1, 2021
Arrma Typhon 3s blx, fits perfectly. Finish is very nice, and the pre-drilled alignment holes are just right for gear meshing, atleast the 20t. Only slight issues were I had to put the pinion on after I mounted the motor loosely. Also I did have to loosen the top retaining clip to slide in the drivetrain, but it's an easy tightening once slipped in. I bought 2, one for my lil bro for his blx. Super impressed, a must have replacement for the whacky waving inflatable arm flailing tube man motor plates.
Chris Cahow
Reviewed in the United States on October 30, 2021
It's a perfect fit and a great replacement for the piece of crap stock motor plate. Just beware you will probably torch your differentials if you run anything other than the 15t pinion. Totally worth it though. I used to have a Hot Racing motor plate but it wasn't much stronger than the stock. I had to frequently use a hammer to flatten out either the stock one or the HR. This one will not bend. It did take about three weeks to arrive so be prepared to wait a while. If you want to use the bigger pinions you'll need metal differentials. Have fun bashing and not having to replace the stock mount every two weeks.
Hooligan RC
Reviewed in the United States on October 27, 2021
The media could not be loaded.
Recommended Products
