Your cart is empty.
Your cart is empty.
※Product Characters:
2GT Belt is good quality,high cost performance,high cost performance make our core pursuit,excellent craftsmanship, more durable,high quality
Neoprene Belt: Good oil resistance,heat resistance and aging resistance
Constant speed ratio,no slip,high transmission efficiency,greatly improve work quality.
※Specification:
Type:2GT
GT2 Pitch:2mm
Material:Rubber
Length:5 meters
Width:10mm
Shape:Open timing belt
※Installation
1,Please tighten the center distance of the transmission device until the tension meter detects that the belt tension is appropriate.
Turn the driving wheel several times by hand to re-measure the tension.
2,Tighten the motor's mounting bolts to correct the torque.Because any change in the center distance of the transmission during operation will cause poor belt performance,
it is important to ensure that all transmission components are tightened
3,Start the device and observe the performance of the belt, check for abnormal vibration, listen for abnormal noise, it is best to turn off the machine,
check the condition of the bearings and motors, or feel too hot to the touch, the belt may be too tight, or the bearings are asymmetric Or inaccurate lubrication
4,It is more convenient to use with the pressure plate. It is used for rubber open timing belt. The PU open timing belt interface is combined with the interface.
The metal block is pressed against the gear bar. The belt is placed in the middle to fix the belt. It is used on the round-trip transmission.
※Tips
1. It is strictly forbidden to twist the synchronous belt during storage and transportation, otherwise the tensile layer will break.
2. The timing belt should be stored in a dry place away from direct sunlight.
Packing:
5 Meters 10mm GT2 timing belt x1
Matthew
Reviewed in the United States on October 13, 2024
Used this to replace a broken belt on a PRUSA mini+. Worked perfectly.
C
Reviewed in the United States on June 15, 2023
Used for a CR10 Max Y axis. The bed is heavy so it uses 2 of these belts and they need to be tight to ensure print dimensional quality. These belts usually last about 4 months, granted the work directly under a bed heated at 120C and in a heated chamber. One part of the belt will give out and stretch causing prints to fail. I cant find a belt that lasts as long as the original so this will have to do for a while.
Lvaladezjr
Reviewed in the United States on March 1, 2023
6mm with a 2mm pitch. Perfect replacement belt for all belts in my Glowforge.
Mohammad Najeeb
Reviewed in the United States on February 25, 2023
I used it for my MPCNC and it works well.
Dan S.
Reviewed in the United States on March 4, 2021
This fixed my broken belt on my Ender 3 v2 X gantry. I just cut it to size, slightly longer than the previous one, folded the ends over and applied two zip ties to each end. I was back up and printing super quickly and have extra if another belt breaks in the future.
Paul J. Feeney Jr.
Reviewed in the United States on September 30, 2020
I purchased this for stock... I have around 15 machines and its good to have on hand
Raymond Witzke
Reviewed in the United States on December 30, 2020
Works as expected, the addition of the pulleys helped also :)
J
Reviewed in the United States on November 21, 2020
I mean, they were EXACT to the dimensions listed and the belt is tough, and doesn't have a stretch I can feel you can't beat the price.
Recommended Products
$19.99
$ 8 .99 $8.99