08 ram seat cushion and cover fit right and good quality!

Easy to install! Looks just like stock seats

This was just like factory. Easy to install and looks great!

If you're reading this, you are probably in the same boat I was. My trusty Ram had hit 200k miles and my drivers seat showed evidence of that. Ah the feel of a cold metal seat frame on a cool winters morning as I would get in my truck sliding across the open canyon that was once foam and fabric. That sensation and my back out of alignment from the slanted worn seat foam finally prompted me to make the decision to buy this seat foam and seat cover combo. Some comments that may help you with this project below:1. You can install this without removing the seat. I unbolted the seat back (torx bolts on the sides) to give me extra room for the install. Note you won't be able to remove it all of the way. My seats are manual adjustment only no electric and the linkage won't allow you to remove it completely but allows you to slide it up out of the way a few inches making the installation much easier especially for the rear foam.2. Unclip the seat cover clips under the seat (front, sides, and rear). The rear has a piece that goes across and clips into itself by the seat belt. Lifting up the seat foam you'll see the rear most clip to undo. There are two nuts under the seat you'll have to remove from the frame to the base to lift it up high enough to remove that clip.3. Install the rear clip for the seat cover first and re-install the nuts for the seat frame to base. Lay the seat cover back against the seat back (if you unbolted it, it should lay back easily). Then install the seat foam. Note: The strips of velcro in the seat foam secure the seams of the seat cover. It is very important you do not push the seat cover into these velcro strips until you have the seat cover properly aligned on the foam or you will have wrinkles and a bad fit).4. Pull the seat cover onto the foam over the front and verify it is properly centered and install the front clip (it kind of folds over itself onto the seat frame to snap in) Some adjustments can be made if it's not perfectly centered after installation of the front clip if it has not been pushed down into the velcro strips.5. Once the seat cover is perfectly centered onto the foam, push the seams into the velcro strips in the seat foam by pushing your fingers into the seam. This will attach the seat bottom to the foam to help prevent it from sliding when you install the side clips.6. Install the side clips and the final rear clips. Note: On my seat the rear clip was sewn on upside down. How I made it work, I removed one of the side clips from the old seat cover. I snapped the two together in the C and used that to attach it to the seat frame.Pros1. Seat foam and cover fit nicely onto the seat. It made the truck seat feel new again. No more sagging crooked seat or bare seat frame.Cons:Seat cover is a much different shade of grey than the factory interior. Even with steam cleaning the seats, it's a much different contrast that is painfully apparent. I ended up buying seat covers anyway because the light grey stains easily. Plus it went into a 200k plus mile truck, I just wanted to be able to sit normally again so it fit that purpose. If you're looking for a factory color match, this may not be the one for you.

Fits perfectly, color good..just had to cut a little hole for the electric seat buttons

The process was simple. The cushion fit as expected. The seat cover matched well. The material that attaches the hooks is quite.thin.One side ripped out but it was on the inside side by the console and it is staying in place nicely.

UPDATE: this comes in two separate packages! The cover arrived on a Wednesday and the foam seat on Thursday.Description states it's the foam seat and a cover. Only the cover arrived, no foam!! Now I have to pay $12.00 to return half the product! We'll see how easy it is to return.

Wouldnt know they were stolen shortly after delivery. Will order again here fairly soon