Your cart is empty.
Your cart is empty.
100% brand new and high quality
MPU-9250 module( 3 axis accelerator, 3 axis gyro and 3 axis)
Chip: MPU9250; Power voltage: 3~5V
Communication mode: I2C / SPI; Gyro range: +/-250, +/-500, +/-1000, +/-2000dps
Accelerator range: +/-2G, +/-4G, +/-8G, +/-16G
Range: +/-4800uF
Pin spacing:2.54mm
Size: 15mm*25mm (approx)
Material: Plastic
Color: Blue
Package Included:
1PCS*9D0F MPU 9250 SPI/IIC 9-Axis Attitude + Gyro + Accelerator Module
Note:
1. Please allow 1-3cm error due to manual measurement. Thanks for your understanding.
2. Monitors are not calibrated same, item color displayed in photos may be showing slightly different from the real object. Please take the real one as standard.
Logan
Reviewed in the United States on February 20, 2025
Mag does not work, I2C cannot detect it on the board and even ran the board on 3V max. Must have arrived dead so I’m going to need a replacement. Very frustrating.
Jordan
Reviewed in the United States on December 19, 2024
Magnetometer gryo accel all axis work. After purchasing I noticed it said something about a 3axis ‘chip’ for accurate motion tracking. Apparently referring to the magnetometer. Thought maybe it wouldn’t work when I got it why wouldn’t they just say magnetometer? But it did, it also worked better than the previous more popular 3pack version. On of those came with a dead gyro axis and the magnetometer didn’t apear to work as well on those. I bought two of these and both worked. I used in several configurations. Two at the same time on seperate spi with on using magnetometer on i2c. It was a challenge figuring out how to get magnetometer working as I’m not a professional Programer and all mpu’s like this on here are likely clones. I used ‘who am I’ to find the correct addresses, and then delayed initialization between magnetometer and ensured magnetometer initialized before gyro and accel. I wasn’t able to get these Amir any other mpus from different suppliers working if I tried putting the magnetometer and gyro accel on the same i2c bus. Probably because of lack of know how. But I did get them working on separate i2c and the version I ended up using was gyro accel on spi and magnetometer on i2c just to have the extra i2c bus on esp32s3 for other sensors. Anyway I hope these stay in stock ordering another right now.
Recommended Products
