Shopping Cart

Your cart is empty.

Your cart is empty.

HappyModel ELRS Module ES24TX Pro 1000mW 2.4G ExpressLRS Micro TX Module RGB LED Module for TX16S, QX7, TX12, X9D Transmitter Remote Control Drone Remote Accessories

4.8 (8) Write Review
Free shipping on orders over $29.99

$53.99

$ 27 .99 $27.99

In Stock
  • The ES24TX Pro Micro ExpressLRS TX module is a upgrade version of ES24TX module.
  • Max output up to 1000mw, reserved Cooling Fan and RGB LED module. This Micro TX module support most of the OpenTX radio transmitter that with Micro JR bay. And this time the ES24TX Pro module comes completely assembled before out of factory.
  • Note: This Micro TX module support most of the OpenTX radio transmitter remote controller that with Micro JR bay, such as TX16S, TX12, Taranis X9D
  • Please make sure the applicability before purchasing, we are always here to assist.


Maximum output power: 1000mW, providing strong signal transmission capability. Built-in cooling fan: Helps the module stay cool during high-power output. RGB LED module: Used to display the status of the module. Supported transmitters: Most OpenTX radio transmitters with a Micro JR interface, such as TX16S, QX7, TX12, X9D, etc. Pre-installed firmware: Comes with ExpressLRS firmware pre-installed, plug and play.


Ronna P
Reviewed in the United States on May 1, 2025
Worked perfectly so far. Will re-review after more tests. Fit my TX16S no problem and flashed latest firmware by AP WiFi after updating radio to EdgeTX. Bound to the two ELRS receivers that I have.
Jack Lawford
Reviewed in the United States on August 28, 2023
Took me a while to setup as I didn’t realize you have to open the body to access the switches internally to allow for new flashes. Otherwise works great and holds an amazing snappy connection.
smp
Reviewed in the United States on June 15, 2023
Great cheap option for getting into ELRS. The build quality is ok, but not on the level of the radiomaster elrs stuff. Still Im happy with my purchase. Using this with a meteor85 w/spi rx and also a zohd drift with a radiomaster pwm rx.
Caleb coleman
Reviewed in the United States on May 11, 2023
I got this for my first elrs module and bind it to the happymodel ep2 and it’s like night and day difference in latency I love it and will never go back the initial setting up process was a pain but a YouTube video and you’re ready to go
Customer
Reviewed in the United States on March 9, 2023
Preflashed with ELRS 3.0 from the factory. No need to repartition Nice job guys!
Adam A
Reviewed in the United States on February 21, 2023
It’s worked flawlessly from the start. Easy to install and use. Have absolutely no complaints. Would buy again for sure.
Romedog
Reviewed in the United States on May 24, 2022
Purchased this sine it was cheaper then crossfire and I was new to the hobby. Easy install and software upgrade
NASH
Reviewed in the United States on February 16, 2022
I did the crossfire mod on the t8sg v3 and plugged in the module. Everything works. Menus populated. No firmware to flash no scripts. Runs the Crossfire protocol.