Shopping Cart

Your cart is empty.

Your cart is empty.

HILLMAN FASTENER 41567 Blue Flat-Head Phillips Concrete Screw Anchor, 3/16' x 2-1/4', 20 Pieces

4.9 (9) Write Review
Free shipping on orders over $29.99

$10.14

$ 4 .99 $4.99

In Stock

About this item

  • Designed to fasten applications into concrete, brick and block
  • Perma-Seal climate coating renders long-lasting corrosion protection
  • High-low chiseled threads cut into concrete allowing for steady drive and installation torque reduction
  • Common uses include anchoring signs/fixtures to concrete and block buildings, flag poles and hurricane shutters
  • 20 pieces per retail package


Product Description

HILLMAN FASTENER 41567 Blue Flat-Head Phillips Concrete Screw Anchor, 3/16" x 2-1/4", 20 Pieces

From the Manufacturer

State of the art thread design cuts into concrete. Tapper screws are designed for fastening applications in concrete, block, and brick. Use Tapper screws to attach electrical equipment, two by fours, downspout straps, hose reels, flag poles, hurricane shutters, and more. Tapper screws are perfect for indoor and outdoor use. For light to medium duty applications.


Don Armstrong
Reviewed in the United States on June 15, 2024
Worked out well.
Reese Matisse
Reviewed in the United States on November 8, 2023
Good quality. Secured decorative items to brick wall
Raul T.V.
Reviewed in Mexico on September 24, 2021
Los utice de acuerdo a las instrucciones pero no da el resultado esperado se supone que es para ahorrarse el uso de los tanquetes y no es confiable el agarre.
Anthony
Reviewed in the United States on December 7, 2018
Make sure your drill bit is way thinner than what the screw requires or else you will end up with a loose fitting in the concrete. And do not worry the screw will still go in Do not use an electric screwdriver , use your hand to fill the tightness and go slow so it tightens properly. .
Eric Campbell
Reviewed in the United States on September 4, 2017
I used these to secure an EVSE to the cinder block wall in my garage (after pre-drilling with a masonry bit). After 1 month, it's still on the wall. No complaints!
Ohad Sheffy
Reviewed in the United States on February 12, 2017
Worked as expected. Make sure to get the right size drill bit as defined by the manufacturer (I think it was 5/16). Once you do that - it'll work better than concrete nails.
Caliber
Reviewed in the United States on April 9, 2016
I used these to help mount a bronze flag mount into a brick column on the outside of my house. I have had trouble with other types of screws but these really worked well gripping the brick. Would buy again.
Ryan Matthews
Reviewed in the United States on May 12, 2015
I'm not sure how these could've worked better. They had clear instructions for how to drill pilot holes and bit into the material very well (in this case my home's brick facade).
DRT
Reviewed in the United States on August 12, 2014
The screws did okay---I just don't like Phillips head screws as much as I do the hex heads. These stripped too easily but perhaps my technique or drill bits are partly to blame. I'm just knocking off a star.