Your cart is empty.
Your cart is empty. Note:The color of the item may vary slightly due to photography and your own computer /Phone
Please allow some little manual measurement error.
Customer Satisfaction Guarantee
If you are not 100% completely satisfied with our products, please do not hesitate to contact us to request a refund or exchange!
Note:Check your specific model's manual for compatibility,or Contact us.
biglarrr
Reviewed in the United States on March 5, 2025
Hard to put a rating on this. It didn't work for my project. The dimensions were right. Length, shaft diameter, and opening for axle shaft were all correct. Pin hole for hex hub was off by at least an eighth of an inch making unusable. It may work for some vehicle, but I can't imagine how. The hex hubs would have to be way thicker and the hub housing way thinner. The ad didn't specify what this might work with.
bornnuts
Reviewed in Canada on July 11, 2021
Use it for my Rc duratrax ect 2 weel drive fit perfect
Realdeal
Reviewed in Canada on March 15, 2021
It’s early and it’s exactly what it said it is and worked out perfectly. Thank you so much
Talha
Reviewed in Canada on February 2, 2021
i used it once and the rod snapped
Jessica Caruso
Reviewed in the United States on February 14, 2020
Exactly what I wanted.
Lucky Brannon
Reviewed in the United States on January 25, 2020
This cost me $12.99 & broke immediately & in the process wrecked a control arm & lost a bearing. So even after I return it for a refund IT WILL COST ME $40 TO REPAIR THE DAMAGE DONE FROM THIS JUNK!!!!!!
Bryan
Reviewed in the United States on April 24, 2020
Worked like a charm
Nick K.
Reviewed in the United States on March 25, 2019
These fit great, super smooth install, the 4mm axle shafts reduced wobble on my 1/10 touring car wheels. Every A9x9 owner should buy this kit! Way better quality than the banggood kits.
GreatImbrokenow
Reviewed in the United States on December 13, 2019
So far so good 4mm nuts definitely hold betterUpdate...broken 2 full sets of these. All in the same spot. To their credit I've cartwheeled it at 60 mph+ and jumped upwards 4' high regularly
Kenny
Reviewed in the United States on April 8, 2019
Great item
Customer
Reviewed in the United States on April 11, 2019
I can't speak for the strength as I've not had the time test yet, but some of them needed to be put in a lathe and turned down just to fit in the bearings. Actually I didnt turn them because they don't turn true. I spun them in the lathe and sanded them till they would fit in the bearings. Oh and if you dont have one, order a small file set or a small file with one side 'half round'. You'll have plenty of deburring to do
Recommended Products
