Mike
Reviewed in Canada on February 18, 2025
Terrible smell like something died when first use. The smell goes away after about 1hr of continuous use
DCK
Reviewed in Canada on April 9, 2025
So far so good. I purchased the resistor on January 5, 2025 and so far as of April 8, 2025 it has worked flawlessly with no issues. Great replacement. It was installed the same week as the purchase.
Neil fode
Reviewed in Canada on September 15, 2024
Replaced when I put in a new blower motor perfect fit
Joan Mcleod
Reviewed in Canada on December 31, 2024
Do not order from this supplier. very poor customer service communication. and miss leading information.first it says part will fit my vehicle.Then parcel lost and refund will be issuedThen go to reorder..NOW....Automotive›Replacement Parts›Engine Cooling & Climate Control›Heating›Blower Motors|! This does not fit2008 Dodge Ram 1500See similar products that fit this vehiclethink they are selling anything/anypart to anyone to up their sales rating.
Bear Bear
Reviewed in the United States on August 9, 2023
Replaced mine while replacing blower and switch…might not of needed…but replaced anyway
K. Ruether
Reviewed in the United States on July 5, 2023
3rd fan speed of the 4 speeds was not working and this quick & simple repair has it working like new.Total repair time, including cleaning, less than 10 minutes.1) Remove 2 Philips screws from resister, (do not lose these 2 screws as new resistor does not come with screws) remove resistor and remove wiring connector from the resister.2) Clean wiring connector with spray electronic cleaner and blow dry with compressor or canned air.3) Coat wiring connector terminals and resistor blade terminals with Dielectric grease to prevent future corrosion.4) Reconnect wiring connector to new resister and install with the 2 SAVED Phillips screws.UPDATE:Lasted 11 months and about 2500 miles.
Richie
Reviewed in the United States on June 20, 2023
Perfect fit. Fixed my ac fan in my Dodge Ram.
Rylee
Reviewed in the United States on November 30, 2023
Ordered this for a dodge ram that was having heating issues. Quick part to replace and the heater works like new.
Robert Hermanns
Reviewed in the United States on June 24, 2022
the old unit was bad, took out 2 screws ,swapped wires and put in two screws. the way it fits you can't do it wrong. 10 minutes and it was done. fit perfect.
Mr Mojo
Reviewed in the United States on February 1, 2021
Though this usually fixes the problem with the fan not blowing, in my case that wasn't the problem, so I'm still searching for another solution and I already know what it is.
Mshaw
Reviewed in the United States on November 20, 2021
Tried to save some money and bought two of these as they are relatively inexpensive compared to the OEM. Install was easy and quick as it is only 2 screws and an electrical plug. 5 stars there as it did match perfectly to the OEM style mount. However both of the resistors I bought burned up, the first lasted about a week and a half, the second only lasted 3 days.ran some electrical tests and the rest of the system has no existing issues that would have caused it to malfunction, so the only thing I can state at this point is that it was a faulty resistor each time.either way You get what you pay for in this case.
Kevin B.
Reviewed in the United States on October 25, 2020
Easy install works perfectly
Guillaume pouliot
Reviewed in Canada on April 29, 2019
Work well on my ram 1500 2002 5.9 liters.