Your cart is empty.
Your cart is empty.Product Description
Description
Do you want your newly painted surface to dry quickly? Then try this infrared paint-curing lamp. It uses an infrared short-wave curing method, can quickly cure the paint, and its a maximum curing area of 16.54 * 19.69in, so it can greatly meet your requirements of efficiency!
Short-wave Infrared Heating:
It adopts the short-wave infrared curing method, which has the characteristics of high luminous efficiency and strong penetration. Such a heating method can dry from the inside out, so the paint surface after curing has high gloss and strong coating adhesion. It can also greatly reduce wrinkles and tears to avoid rework.
High Efficiency:
Its working temperature can reach 200℃, and it uses a special internal high-reflectivity reflector to make the heat more evenly distributed, which can increase the curing area (16.54*19.69in) and reduce the curing time.
Timer Function:
You can set the time of curing within 0-90 minutes by turning the knob on the back of the light according to the paint surface, which is convenient for you.
Height and Angle Adjustable:
We equip you with a telescopic stand, you can adjust its height between 25.59-59.84 by adjusting the two knobs on the stand according to your needs. And you can manually adjust its working angle up to 270°.
Good Heat Dissipation:
Its housing is aluminum housing and has the feature of fast heat dissipation. It has numerous small holes on the back of the heat sink, which can greatly enhance its heat dissipation capacity and effectively improve its service life.
High Safety:
It will automatically shut down at the end of the timer, so you don't have to worry about the safety hazards caused by its long and hot operation.
Application
It can be used for automotive painting, field maintenance, engine drying, stripping, putty drying, primer drying, partial paint drying, or preheating before painting.
Details
Handlebar: The design of the handlebar increases its portability while also allowing your paint to be cured everywhere.
Screw Holes and Slide Rails: It has screw holes on both sides to allow you to install the appropriate brackets as needed for your convenience. The design of the slide rail also allows you to combine 2 or more infrared paint-curing lamps.
Net Cover: The net cover is made of high-gloss chrome, which is not easy to rust while its proper grid spacing will not cut the efficiency of the infrared paint-curing lamp.
Installation
1.Mounting Base: Remove the nuts manually. Adjust the bolt to the middle position, align the two holes on the base and place nuts, then tighten the nuts.
2.Mounting Connection Plate: Align the female through holes in the connection plate with the holes on either side of the mounting plate. Tighten the nuts to ensure the connection plate is perpendicular to the mounting plate.
3.Connection Bracket: Remove the swivel nut at the top of the bracket, align the hole in the middle of the connection plate, and tighten the nut.
4.Height Adjustment: The free retraction of height is achieved by two rotating devices on the bracket.
MADISON PATE
Reviewed in the United States on March 27, 2025
The heat is spread very evenly. I can depend upon my part being approximately 15 inches from the lamp and hold a steady 140° Surface temperature for drying
Recommended Products
$32.99
$ 15 .99 $15.99