Your cart is empty.
Your cart is empty.Product Description
Usage:
- 1. Switch to the "ON" position and wait for the product number to be 0. Before the number becomes 0, your fingers cannot touch the upper and lower metal pieces, otherwise it will affect the measured value.
- 2. keeping the thumb and the square in front of the sheet metal, the metal plate toward the back of the air tested negative ion generator, and tested the closer air anion generator tester readings higher, whereas smaller. Therefore, to ensure the accuracy of the measurement results, leave the meter and test negative ion generator to maintain an appropriate distance.
- 3. the measurement process, do not touch the metal piece to the back of the instrument, otherwise it would be inaccurate readings.
- 4. If the reading is not preceded by the measurement symbol is measured positive ions, if the display "-" is negative ion surface.
- 5. To re-measure should first turn off the power, then restart it.
- 6. The measurement method textiles: the thumb in contact with the front metal plate, the metal plate toward the back of the textile gently rubbing test, the display will show the ion concentration and to polarity, which can produce ions as the ability of a fabric kinds of important reference.
- 7. To measure again, you need to shut down and restart, and repeat the above steps.
AIT (P) ion meter advantages:
- AIT (P) anion ion gauge is AIT gauge improved, it is the biggest difference between the AIT is the maximum value of the measured air ions remain on the display, it will give the instrument readings more stable, easy to read . Before each measurement to confirm the switch in the "off" position, when you start to make the instrument away from the object, so that its initial reading of zero or close to zero regulation and then slowly close the ion source. It displays the reading will remain until the power is turned off.
Ryan
Reviewed in the United States on April 5, 2025
1) This tester is only accurate if you calibrate it with a real ion tester (according to it's own instruction manual)2) You must hold your finger on a square piece of metal for it to work.3) The readout has in large numbers 001. Which tells you nothing because in very small numbers is the real reading x10^X. The X is very small and difficult to see.4) It is recommended that it be worn as jewelry or hung as a decoration.Because it claims to not be accurate, and has what appear to be intentionally extreme design flaws, it falls in the prank product category.
Recommended Products
$105.00
$ 45 .99 $45.99