Your cart is empty.
Your cart is empty.Product Description
IR Keystone IR Receiver for Remote Control Repeater Extenders
IR confirmation LED provides user feedback when IR signals are sensed Specification:
- Receive frequency range - 34 KHz to 60 KHz
- Transmit frequencies - 38 KHz & 56 KHz Range - 40ft. @ 38 KHz - 25ft. @ 56 KHz
- Power - 12VDC, 30mA max.
- Dimensions - 39.5L x 19.3W x 24H mm
- Connector type - Spring Clamp Terminal Block Wire range - 20-26 AWG
Professional IR Repeater Extender Keystone Adapter
It's simple to Install:
- Mount the Keystone IR Receiver in any standard Keystone Wall Plate.
- Run Cat5 cable from the receiver to the IR Block connecting block. (2 twisted pairs required, shielded or unshielded).
- Then all you have to do is aim your remote control at this IR Receiver, which will automatically send the signal through to your devices!
Installation Notes and Hints -
- Strip back approximately ½” of the conductor on TWO of the pairs.
- Match the connection markings from the In Wall Infrared receiver wall plate to the connecting block of the advanced IR receiver.
Installation Note - To avoid possible noise interference from induction from 115 VAC, never run low voltage and AC lines together. Installation Hint -For best appearances, mount the device at the same height as installed light switches.
Room Placement: Place IR Wall Plate in direct “Line-of-Site” of the hand held remote control up to 25’ away and within a 120° of the device.
Blue W.
Reviewed in the United States on May 28, 2017
I bought this to replace a 12v IR extender sensor that I fried accidentally. This worked great and was so much cheaper than buying the name brand replacement.
Glen
Reviewed in the United States on February 22, 2017
The angle isn't like I hoped, but it does the trick when I point directly at it. The dark clear color makes it look like keystone plate has a hole, so I recommend a different face color module that blends in with the white faceplate.
Recommended Products
$104.00
$ 51 .99 $51.99