• After the respirator components have been cleaned and inspected, place them in a plastic bag or an airtight container. Store the respirator parts away from excessive heat, dust, cold, moisture or harmful chemicals.

This respirator must be supplied with clean breathable air, Grade D or better, at all times. The BLASTING HELMET does not purify air or filter contaminants. Breathable air must be supplied to the point of attachment of the Safety air supply hose.Supplied breathing air must at least meet the requirements for Type 1 gaseous air described in the Compressed Gas Association Commodity Specifications.

• BREATHING AIR PRESSURE:

The air pressure must be continually monitored at the point of attachment while the air is flowing to the respirator. Air pressure must be read from a reliable pressure gauge whilst the respirator has air flowing through it.

• HEAD HARNESS:

To adjust the head harness first unclip the locating pegs, then slide the band in or out to the desired size. Note: slide inwards to reduce the size. Once the desired size is obtained, clip the locating pegs back together.

• DOFFING YOUR HELMET:

To remove the helmet, first exit the working area and reverse procedures in Respirator Use. !WARNING! NEVER remove your helmet when in the working area.

• STORAGE:

After the respirator components have been cleaned and inspected, place them in a plastic bag or an airtight container. Store the respirator parts away from excessiveheat, dust, cold, moisture or harmful chemicals.

INTRODUCTION

The JM BLASTING HELMET SUPPLIED - AIR RESPIRATOR is specifically designed for use during Abrasive Blasting. blasting helmet/fresh air blasting helmets/sand blasting helmet hood/dustless blasting helmet/blasting machine/blasting wire/blasting gun/safety helmet/fire safety helmet/gloves. The JM BLASTING HELMET has been designed for use in atmospheres NOT IMMEDIATELY DANGEROUS TO LIFE OR HEALTH, and from which a user can escape without the aid of the respirator.fire safety equipment/blast safety mask/safety hood/cap/sandblaster/helmet/protective gear mask/helmet tools protector. The JM BLASTING HELMET to provide respiratory protection in abrasive blasting and painting applications. The cape is designed to protect the wearer’s upper body from rebounding abrasive. Marketed By SIGNAMIO.

AIR SUPPLY HOSE

The air supply hoses should be inspected for:

1. Cuts or tears

2. Cracks or signs of perishing

3. Blisters or weak points

4. Abrasive wear the hose or are not worn, remove any dirt inside couplings with a duster gun.

5. Ferrules firmly crimped in place

6. Quick disconnect couplers do not move in.

STORAGE

After the respirator components have been cleaned and inspected, place them in a plastic bag or an airtight container. Store the respirator parts away from excessive heat, dust, cold, moisture or harmful chemicals. After use hang the respirator up by the hand strap, this will help keep the inside of the helmet free of contaminants.

BREATHING TUBE ASSEMBLY

Inspect the breathing tube for cracks, tears or excessive wear. Check that the fittings are secured into the cuffs tightly, not allowing any air leaks. Replace the hose as soon as any signs of damage or excessive wear become evident. Do not remove the foam that is inside the breathing tube as this is a critical component.

Head Harness

To adjust the head harness first UN clip the locating pegs, then slide the band in or out to the desired size

WARNING!

Air leaks will cause a drop in air flow through the respirator helmet resulting in less protection from contaminants