Your cart is empty.
Your cart is empty.The JR Products Fresh Water Fill Diverter Valve takes the place of a gravity fill on newer units and diverts water from the city water fill to the fresh water holding tank.
Serge Lavoie
Reviewed in Canada on July 8, 2023
Good Products !😊
Customer
Reviewed in the United States on June 4, 2023
It works kind of. The check valve for the city side is not working. When you un hook the hose the water wants to shoot out when the valve is on the city position
Diane
Reviewed in Canada on September 16, 2022
Product worked and installed easily
Terry
Reviewed in the United States on December 4, 2021
Exactly as the original and went in easily
Donald Meeker
Reviewed in the United States on October 12, 2021
Easy to install and everything fit perfectly
Joseph Francis
Reviewed in the United States on June 20, 2019
I ordered this part and it came 1 day early. It’s expensive but they do not make this type of valve in brass. I would have paid more if they had a brass version. Plastic and cheaply made.
SAFBUYS
Reviewed in the United States on November 29, 2018
This is an expensive item that will only work if you have the exact same model originally. Most large Class A coaches use a Swan and the form factor is different plus the parts are metal. I had to return this because cutting and modifying the mounting area was not possible. I felt the plastic was a poor design too.
Wendy
Reviewed in Canada on August 17, 2017
Prefect replacement for a fraction of the cost of a part from a RV dealer
BW
Reviewed in the United States on November 15, 2017
It was exactly what I needed, and identical to the valve I was replacing, fortunately. It came with a variety of fittings attached to each of the three ends (water inlet, house pressure, and tank fill) but I didn't need most of them on my application since the existing RV fittings were exact matches (again, because the valve being replaced was identical to this one. The connections are good quality compression fittings, no need to mess with teflon tape, etc - just hand-tight compression fittings. Hooked everything up and no leaks, which I consider a major DIY success and saved a hefty repair bill. My only two complaints are 1) a diverter valve is a fairly basic plumbing component, but this one is severely overpriced only because it's an RV-specific product. 2) the valve itself (the part that the blue handle controls) seems prone to failure. In my case, the internals stripped out on the original due to regular use of the handle motion. If you have this valve on your RV, it may be wise to remove the blue handle with a small screwdriver, then behind that is a very small phillips screw which if it comes loose it may strip out and cause the valve to fail eventually. If the handle feels "loose" during use, try taking the handle off and tightening the phillips screw behind it. In my case, the plastic that the back screw goes into was already stripped out and would not tighten, thus resulting in water spraying out every time the water was turned on.
VGK fan
Reviewed in the United States on September 19, 2015
Way overpriced for what it is, but this is one of the lower prices around. Product is DVF-1-A with the blue handle. (Picture is not accurate - shows DVF-1-W)
John
Reviewed in the United States on January 3, 2015
I ordered this to replace the original valve that failed. This one sort of works but it doesn't work as it is supposed to but I've managed to do a work around! The price is too high for what it is...
Recommended Products
