Your cart is empty.
Your cart is empty. This listing is for a New After Market SeaDoo Wear Ring
Fits the following Sea-Doo models and years
2004 GTX 4-TEC Supercharged
2004 GTX 4-TEC Limited Super Charged
2005 GTX 4-TEC Supercharged
2005 GTX 4-TEC Standard
2005 GTX 4-TEC Wakeboard Edition
2006 GTI SE
2006 GTI STD
2006 GTX 4-TEC Supercharged
2006 GTX 4-TEC Standard
2006 GTX 4-TEC Wakeboard Edition
2007 GTI SE
2007 GTI STD
2007 GTI 4-TEC SE NA
2007 STD AND WAKE
2007 RXP NA
2008 GTI 130
2008 GTI SE 130
2008 GTI SE 155
2008 GTX 155
2008 WAKE 155
2008 RXP 155 OEM Part #: 267000104
REFRIGERATE FOR AN HOUR BEFORE INSTALLING FOR BEST RESULTS
SEA DOO Oem Numbers this part replaces: 267000104 271001236 267000419 267000021
Customer
Reviewed in the United States on February 26, 2025
Did not like
chris roach
Reviewed in the United States on June 26, 2024
This fits in the pump fine after being in the freezer it just drops right in. But it is not milled down enough to allow the impeller to fit inside it. It is defective. I remove the impeller installed this and then had to cut it out because it will not allow the impeller to fit. I bought a Sea-Doo OEM part and it was a five minute job.I have several more pictures I may load up later
Customer
Reviewed in the United States on September 18, 2023
As with many products there are many happy with their product and as many disappointed. This product fit perfectly in my 130GTI Seadoo. You have to "chill" the product to shrink it to fit. Worked like a charm! You will see in the reviews it did not fit for some. I would argue that if they read other's reviews and/or instructions they would have been fine. First I put it in the fride overnight which provided nearly perfect results. Secondly, I dropped it in the freezer for an hour which worked.
Greg
Reviewed in the United States on September 30, 2019
Runs like new now!
Bondski
Reviewed in the United States on August 22, 2019
Are you kidding? I now have more prop clearance than my old worn wear ring had.... don’t buy this.
CA Hiker
Reviewed in the United States on May 28, 2019
Cross checked part numbers from seadoo and what is stated to replace. Does not fit in my pump OD too large ID is off as well, my worn out ring is a tighter fit to the prop than this one would be when comparing. Amazon however made it right and continues to get my business.
lexusace
Reviewed in the United States on August 24, 2018
the fit of this seadoo wear ring is far better than any aftermarket wear ring I have used! most other than the factory part,fit too loose in the pump housing . this is a great replacement ,at a great price.
Frankie Aponte
Reviewed in the United States on November 9, 2018
This wear ring had a very poor fit on my 2004 Seadoo GTX. The outer diameter was too large. Even after freezing the ring and pump overnight, it still would not fit. I had to shave away about 1mm worth of material from the outer ring to get the ring to fit and then pound the ring into place.Once installed, there is too much clearance between the inner ring and the impeller. So although performance is better than it was with my worn out ring, it's not what it should be with a brand new ring. I will not get the life out of this ring that I should. I own two Seadoo GTX's, '04 & '05 and replaced the wear ring on both. For my other I opted to go with a more expensive one from another supplier and that one fit perfectly and a very tight fit both inside and outside of the ring. I would NOT recommend this wear ring to anyone.
Recommended Products
$33.32
$ 14 .99 $14.99
$14.49
$ 6 .99 $6.99
$119.95
$ 50 .99 $50.99
$23.99
$ 10 .99 $10.99