Shopping Cart

Your cart is empty.

Your cart is empty.

JT Sprockets JTF516.14 14T Steel Front Sprocket

Free shipping on orders over $29.99

$16.25

$ 6 .99 $6.99

In Stock
  • Made from SCM415 chromoly steel alloy


JT Sprockets ensures maximum durability and performance through accurate machining and using only the best grade of SCM415 chromoly steel alloy. Heat treated and hand finished to perfection, all JT Sprockets meet or exceed the highest possible quality standards for the powersports industry. Each sprocket goes through 10 quality control checks before it leaves the factory.


Tim Cranor
Reviewed in the United States on September 2, 2023
Perfect!...
Nelson R.
Reviewed in the United States on July 16, 2023
Exelente
Cloves
Reviewed in the United States on April 2, 2021
JT's website says this fits newer klx250's and it does, sort of. The splines are really tight so it will fit on the counter saft but it requires a lot of pressure to put it on unless your countershaft is old and worn. I didn't end up using it because I wanted a proper fit not press fit. I went with a "primary drive 34213". It fit well. I don't know about the quality or longevity but we will see. It also fits the new klx300.
d-unit
Reviewed in the United States on May 1, 2018
went down -2 in the front of my gs500, its still slow but a great product
Robert Lee
Reviewed in the United States on June 13, 2017
Great job..thanks
Shannon
Reviewed in the United States on April 10, 2017
Fit perfect on my KLR250, ended up back with the stock 15t for less revs on road but 14t is slightly better in dirt.
robert
Reviewed in the United States on July 26, 2014
Not a good quality product or just not the proper part . Not wide enough for the nut to tighten down on Only has a flange on 1 side should be on both sides like the oem sprocket or the Sunstar brand witch fit perfectly.
OT
Reviewed in the United States on June 27, 2013
This JTF516 fits the KLR250 whereas JTF512 did not on my application. JTF516 has the smaller inside step like an OEM sprocket so it does not sit against engine case like a JTF512 would. Check it out before buying and make sure you are getting the right one. Machining quality on these is perfect! A true bargain with Prime.