Your cart is empty.
Your cart is empty. Details:
Overall Dimensions: 3 ¾”W x 3 ¾”H
Faceplate Dimensions: 3 ½”W x 3 ½”H
Bolt hole spacing: 2 15/16”W x 2” H (hole center to hole center)
K101 “pigtail” wiring harness included
12V DC
Color: White or Black
Easy readout
Monitor tank levels
Monitor battery level
Control for water pump
Controls for electric and gas water heaters
George
Reviewed in the United States on March 28, 2025
On the front in picture and when you physically have it it’s says 3 way pump on the front I spoke with Kib electronics customer support. no wonder there was only 1 red wire . They said I need the Kib m25 2-3- hbl one which I can’t find in stock on Amazon currently and Can’t use this and past the return date .
Kindle Customer
Reviewed in the United States on February 2, 2025
My 2009 5th wheel had a white panel with 5 indicator lights. Black was OK, but my pump switch was wired 3 way with another at outside water hook up. I just reclaimed the old switch and wired hot to middle terminal like original. Works now but without new lighted switch. Only reason I gave a 4 star review. New switch small print said 3 way not available, but I didn't see it listed in product description.
Don
Reviewed in the United States on January 9, 2025
No problem with it.
Bill a la Kill
Reviewed in the United States on August 4, 2024
Replaced an older model of the same brand and while there was great similarity in the connections, it was not plug and play. All the colors matched, and it was possible to use the existing female spade connectors after some head scratching, although it was necessary to directly splice in the main power and ground wires. Also all the sense wires from the tanks (which go to a smaller connector on the unit) needed direct splicing to the dangling wires.I used inline splice connectors which allowed me to preserve the old small connector in case I needed to re-install the old unit. I was afraid the new one might not work, but it did work meaning I created some unnecessary wiring complexity.The straight forward approach would be to cut all the wires and just splice them in one for one (the color codes should match). Even that it is a bit daunting if you’re not familiar with boards and wires, etc.LASTLY, I should note that if your replacing this because the tank sensors are not operating correctly, there’s a good chance it’s the sensors at the tanks not working and a new monitor unit won’t fix it. In my case the old faceplate was melted (from nearby stove) and the buttons were barely working. The new panel looks great and I feel blessed that all the tank sensors work as they should in my 2006 fifth wheel.
Kathy Patton
Reviewed in the United States on July 22, 2024
My husband said it does what it was made for and glad I got it for him.
Did not work, had to order another one.
Reviewed in the United States on December 3, 2024
Had to take everything apart and put together to find out it was a defective part.
Kenny
Reviewed in the United States on August 12, 2023
The product was easy to install it was basically a wire for wire install. I was replacing an older two switch panel
MaryAnn Snyder
Reviewed in the United States on November 11, 2020
Direct replacement snapped in place
Recommended Products
