Your cart is empty.
Your cart is empty.This is a solid resin beer tap handle of an arm bone. This was hand-painted and measures approximately 11 inches tall, and 2 inches wide This will fit standard US faucets The base in the photo is NOT included
Randy Gray
Reviewed in the United States on September 29, 2022
Looks great in my outdoor bar area
Daniel Pitmon
Reviewed in the United States on August 8, 2021
Cheaply made. Broke unboxing it.
Anas
Reviewed in the United States on October 14, 2021
Great details. But with one small problem, the screw on the bottom was off center
Michael Rodrigues
Reviewed in the United States on October 31, 2019
Exactly as described and well made for a beer tap. But I used it as a shift knob for my 92 nissan hardbody. Lol. It's really cool until I make it more permanent.
Matthew Tofft
Reviewed in the United States on December 20, 2018
The resin used to make this tap handle isn't very strong out of the box I dropped it on my kitchen floor and It broke in half... successfully glued it back together and it worked fine for a while then one day my handle got stuck and i pulled hard to get it to release and it broke again in a different spot from the previous break. Looks good and has a nice weight to it... just gotta be careful with it I suppose...
Scott Fitzgerald
Reviewed in the United States on July 11, 2015
awesome!!!
Recommended Products
