Shopping Cart

Your cart is empty.

Your cart is empty.

LINKITOM 6 Inchs Submersible Oval LED Stop/Turn Trailer Tail Light with Waterproof Rubber Gaskets for Boat Trailer Truck RV [DOT Certified] [IP67] (2 Pack)

Free shipping on orders over $29.99

$19.99

$ 8 .99 $8.99

In Stock

About this item

  • Super Bright: 24(16+8) bright LED diodes with super high visibility, light up the rear or side of your vehicle or trailer in daylight, midnight, raining or fog days etc any weather condition. Improve the driver security and avoid accidents.
  • Waterproof and Submersible: The housing is design of excellent moisture-proof sealed and IP 67 waterproof makes it be definitely waterproof.
  • Compliant with DOT standards: The lamp shade of utility trailer light kit with corrosion resistant ABS material, Durable design for years of use. SAE DOT certified
  • Easy Installation: Standard 6" size. Each light comes with an industry standard connector with 12" of wiring for installation. Included black rubber grommet makes for an extra easy surface mount setup - no holes or screws required. Install your lights in mere minutes. Dimensions with grommet are approximately 7.5”x 3.25”x 2”.
  • Brake& Turn Taillight: Function as tail lights or turn/brake lights. Fit for heavy truc, trailer, boat, bus, lorry, van, caravan, snowmobile, etc.,



Product Description

Oval LED Tail Light

6" Oval Trailer Tail Lights, keep your driving safety.

Fitment:

Suitable for trucks, trailers, ships, buses, trucks, trucks, caravans, snowmobiles and other 80-inch-wide trailers.

Features

SAE and DOT FMVSS-108 Certified

6'' Oval Industry Standard Size

24 LEDs with Red Lens, 2 pack

Submersible Waterproof IP67 Rating

Grommet and Connector Included

Super Bright

Super Bright

24(16+8) bright LED diodes with super high visibility, light up the rear or side of your vehicle or trailer in daylight, midnight, raining or fog days etc any weather condition.

Durable Shell Housing

Sturdy Shell Housing

The lamp shade of utility trailer light kit with corrosion resistant ABS material with black rubber grommet, protect the whole LED light bar effectively.

IP67 Waterproof

IP67 Waterproof

The 6 inch tail light is seal. So the water will not damage the diodes or circuit board. excellent tightness makes it be definitely waterproof .

Easy install

Easy install

Each light comes with an industry standard connector with 12" of wiring for installation

How to install?

1.White wired: Groud

2.Brown wired: Tail light

3.Red wired: Brake/Turn light


Lauren T
Reviewed in the United States on July 14, 2024
Boat trailer light replacement. Looks good and puts out good light. Rubber gasket is not as flexible as my original., Rubber compound different. I reused my old light gasket to make installing the light easier.
Galen L. Erisman
Reviewed in the United States on December 20, 2024
Worked well on the back of trailer
Al
Reviewed in the United States on December 15, 2024
I have a Ford F650 super duty and these lights are to replace some lights that are on the bed of this vehicle. Have a custom bed and they are bright. I love them excellent value.
JP
Reviewed in the United States on September 13, 2023
The media could not be loaded.
M. Galvin
Reviewed in the United States on July 26, 2023
Install was super easy as they fit right in my old gaskets on my EZ-Loader trailer and the low voltage plugs, cirta 2001 was plug and play so no messing with wiring other than to plug in. Seem bright enough with definite contrast between the tail light and the brake/turn signal. As far as waterproof, again, so far, so good. They have been submerged 4x thus far and no leaks. Also, great price as compared to local stores.
Dany
Reviewed in Canada on July 23, 2023
Parfait !Exactement ce que je voulais.
SilentSeven
Reviewed in the United States on June 3, 2023
Edit: NOT WATERPROOF! LEAKED AFTER ONE USE.Just installed - here's what you need to know.First the wiring connectors are junk - the wires are super thin and strands break off when stripping. They also angle straight out from the light so you'll likely have wires sticking out if your wiring comes in from the side. The lights use a Truck-lite style 3 pin fitting and the Truck-lite 90 degree connector will fit with a little finagling. To make the Truck-lite connectors work, I had to use a razor blade to slightly relieve a portion of the Truck-lite fitting and then also slightly open up the female fittings on the LED lights. Wallah! Then the much superior Truck-lite harnesses pop right in.Second - the black mounts are junk again vs the truk-lite versions. These lights will fit into the Truck-lite brand mount and I would also recommend using those.Lights installed look and work OK. We'll see on longevity.
Daniel R.
Reviewed in Canada on December 18, 2023
They still work very well after almost a year.
Matthew Duke
Reviewed in the United States on July 16, 2022
The brightness is great, super easy to install, but they are not sealed at all. Replaced the old lights with these earlier in the year. Haven’t been to the lake but 5 times and one is already not working. The defect one is full of water and shorted out and the other won’t last much longer as it is also full.DO NOT BUY!!! Spend the extra money on a good quality set and you will be doing yourself a favor!!
Minnitana Hobies Farm
Reviewed in the United States on March 12, 2022
I used these to replace original LEDs that were 9 years old and loosing eliments. The 24 LED design is much better than the old 10 element system. Center line is Tail/Marker and outer ring is Stop/Turn. No one should miss my lane changes now. Fit in the old rubber gromits and plugged into the old pigtails perfictly. The gromits sent with were of a lighter design so I kept them as spairs. though they would have worked well.
Recommended Products