Your cart is empty.
Your cart is empty.Barry mickokiner
Reviewed in the United States on March 29, 2025
Haven’t installs yet but look great
mamtha h.
Reviewed in the United States on January 5, 2025
Highly commendable service and timely delivered
joe
Reviewed in Canada on January 28, 2025
Works goo, very bright
Rafael Valenzuela
Reviewed in the United States on January 26, 2025
Only thing i disliked was the thickness of the wire but overall works just installed them 1/22/25. We’ll see how they hold up
Roger D. Evans Sr.
Reviewed in the United States on June 29, 2024
Works great and is very bright
FUNKY MONKEY
Reviewed in the United States on October 22, 2024
These lights light up my license plate really good.
Mohammad alshaibani
Reviewed in the United Arab Emirates on August 20, 2023
قوي
Conrad Cornwall
Reviewed in Canada on February 4, 2023
Nothing
Fernando H.
Reviewed in Mexico on January 5, 2023
Cómo alumbra placa.en una caribe.
Carlos E Martinez
Reviewed in the United States on January 25, 2023
Easy to install. Just like anything automotive, one black ground and one red power wire. Place it where you want it and drill the holes through the holes on the light fixture and install the two screws supplied with the assembly. I installed both, big mistake. I recommend placing one in the middle above the license plate and attach it there. The two on each side is way too bright. Other than that they work great.
Robert M
Reviewed in the United States on November 26, 2020
These look well made and probably would work like gangbusters if you can install them, but unfortunately, they did not fit my 1999 Ford Windstar despite Amazon telling me they do. The center to center of the installation holes is off by a few millimeters. I would usually just make up an installation bracket or drill new holes, but neither was possible due to spacing.
Manuel Gonzalez
Reviewed in the United States on October 13, 2020
I liked the brightness of the lights, but they did not fit my 2004 ford explorer xlt as described, they are too small, I had to splice wires in order for them to work had to use the old screws because the screws that came with lights were too thin and would not hold. Once installed there was a gap and I used a sealant to fill the gap.
Recommended Products
