Shopping Cart

Your cart is empty.

Your cart is empty.

M5 Inductive Proximity Sensor Switch Shield Type LJ5A3-1-Z/BY Detector 1mm 10-30VDC 150mA PNP Normally Open(NO) 3 Wire

Free shipping on orders over $29.99

$9.49

$ 4 .99 $4.99

In Stock

About this item

  • Mounting Hole Diameter: 5mm; Cable length: 200cm/78"
  • Detecting Distance: 1mm±10%; Set distance: 0-0.7mm
  • Output Type: PNP NO(Normally Open), Shield Type
  • Current Output: 150mA; Working Voltage: 10-30 VDC
  • Detect Object: Magnetic metal


  • Detection Object: Magnetic metal(the detection distance decreases when it is non-magnetic metal).
  • Delay Distance: 10% below of the detection distance.
  • Supply Voltage:DC10-30V Impulse (p-p)10% below.
  • Comsuption Current: 13mA below.
  • Control Output:150mA below.
  • Loop Protection: Reversal connection protection,surge absorption,load short-circuit protection.
  • Ambient Temperature & Humidity:During operation, storage: individually-30~+65℃(no freeze ,no drew ), During operation,storage:individually 35-95%RH.
  • Insulation Impedance: 50MΩ above ( DC500 megameter ) between charging part and shell.
  • Withstand Voltage: AC1000V 50/60Hz 1 min. between charging part and shell.
  • Temperature Influence: Temperature range-30~+65℃,at + 23℃,± 15% detection distance, Temperature range-25~+60℃,at +23℃,±10% detection distance.
  • Voltage influence: Inside ±15% rated supply voltage range,at rated supply voltage value ,inside ± 10 % detection distance.

TheGeckoGuy
Reviewed in the United States on March 11, 2025
This inductive proximity sensor is a useful little component that seems to work as expected. While I wouldn’t rely on it for industrial environments, it’s great for projects around the house or prototyping where high durability isn’t a concern.The cable is plenty long for most applications, making installation more flexible. The sensor body is externally threaded and comes with two nuts, allowing for easy mounting to a small bracket. Overall, a good choice for non-industrial applications where a simple proximity sensor is needed.
Cliente
Reviewed in Spain on September 3, 2024
Pedi 3 sensores, llegaron rápido pero no se corresponden con las medidas de la imagen anunciada.Los necesito que la luz led este a una distancia minima de 30mm puede estar en la entrada del cable.Resumiendo necesito 3 Sensores M5 PNP NO CON LED AUNA DISTANCIA MINIMA DE 30mm.Pediría otros pero me arriesgo a lo mismo.Una maquina esta parada por esta causa.
T. Müller
Reviewed in Germany on October 27, 2024
Funktioniert.
LUIGI
Reviewed in Italy on July 3, 2022
SENSORE FUNZIONALE DAL PREZZO ECONOMICO ARRIVATO RAPIDAMENTE
Customer
Reviewed in Italy on November 17, 2022
Ne ho acquistati alcuni, l'ultimo che ho acquistato non funziona. Uscita PNP sempre attiva e led sul sensore non dà segno di vita.