Your cart is empty.
Your cart is empty. This is a dual mode wireless NIC module applicable for Jetson Nano, supports 2.4GHz / 5GHz dual band WiFi and Bluetooth 4.2.
Features
Chip: Intel 8265AC
Bands: 2.4GHz / 5GHz
Speed: 300Mbps / 867Mbps
WiFi protocol: 802.11ac
Bluetooth version: 4.2
NIC interface: NGFF (M.2)
Antenna interface: IPEX connector
Supported OS: Linux, Windows 10/8.1/8/7
Dimensions: 22mm × 30mm × 2.4mm
PACKAGE CONTENT
1.Wireless-AC8265 x1
2.Antenna x2
3.IPEX to SMA cable(7.87inch / 20cm in length) x2
4.Scrwdriver x 1
5.Assembly Instruction Manual
Kaiko89
Reviewed in the United States on February 8, 2025
Comes with all parts and tools needed for installation.Easy install, both antennas are required to be connected for proper reception, though I did swap out one of them to a smaller antenna for my sffpc.
Reuben L.
Reviewed in the United States on April 10, 2025
Cheap wireless + BT add-ons for mini/small form factor PCs that didn't come with these wireless nor bluetooth. You may need to jerry-rig a spot where the antenna protrudes from your device.
TAZMDVL
Reviewed in the United States on May 5, 2024
I put this wifi card into a HP EliteDesk 800 G2 Mini as it did not come with one. I looked at a lot of cards, did a lot of research and found it almost hopeless as to which wifi nic to buy. Then I came across this little kit it had everything including zip ties and a screw driver. In other reviews they had mentioned the same M.O.B. It was the right pice/no brainer, windows recognized it no problem including the Bluetooth. One of the easiest installs I have done in a long time. I will mention that the antenna leads are difficult to put on the nic card!
Larry A. Lovering
Reviewed in the United States on May 29, 2023
I bought this kit because my HP Elitedesk Mini 800 G3 didn't have wifi or bluetooth. After perusing the documents for the PC, I discovered more than the wifi card, Makeronics had a complete kit. The card, antennas and cables were perfect. The only issue, and I knew it existed from other reviews, was connecting the antenna wires to the card. It took me a couple of hours, and I removed the card to put it on a flat surface. All works great!
Coleman Martin
Reviewed in the United States on May 27, 2023
I put one of these babies in a refurbished HP Elite Desk G2 800. This model has a wifi option but it was not included in mine. There were pop out holes for the antennas and everything fit exactly as it should. No fuss, all recognized by software, in my case Ubuntu.
Customer
Reviewed in the United States on March 14, 2022
Works fine with 2.4GHz Wi-Fi but could not get 5GHz to work, no obvious reasons why — the device appears to support 5GHz.
G. Stevens
Reviewed in the United States on December 30, 2021
I used this card to add WiFi to an HP 800-G2 Mini Desktop PC. WiFi was an option on this computer, but it did not have the needed M.2 card or antennas. This kit was perfect for this PC, with just the right amount of antenna cable length, and all the parts needed. I installed it, booted into Windows 10, and the Intel AC 8265 wifi and Bluetooth drivers loaded automatically. The IPEX connectors for the antennas are a pain in the butt, but that's not strike against this particular card, just the nature of the beast. (Pro tip: Install the cables before you install the card. Also, push directly down on the micro-coax connector, do not attempt to angle it in.) Couldn't ask for a better kit for my circumstances.
Han Ooi
Reviewed in the United States on July 25, 2020
I followed the instructions on this kit and installed the M.2 board onto my Jetson Nano. Everything works on bootup.This kit brings all the components you need into one easy place where you can install BLE and WiFi connectivity without having to make multiple runs hunting for the proper components.
Recommended Products
