Your cart is empty.
Your cart is empty. New For Various GM Models 3 BAR MAP Sensor with Connector Pigtail
Map sensor range - 3 Bar
Map Sensor range PSI- 44psi
Replace Part #12223861 / 16040749 / 12223749
Fits following vehicles
*Must check part number to match. Could NOT work for all engines
for Buick Century 1982-2002
for Buick LeSabre 1988-1989
for Buick Regal 1985-1996
for Buick Rendezvous 2002-2003
for Buick Roadmaster 1992-1996
for Buick Skyhawk 1982-1989
for Buick Skylark 1983-1997
for Cadillac Cimarron 1985-1988
for Cadillac Brougham 1990-1992
for Cadillac Fleetwood 1993-1996
for Chevrolet Astro 1985-1994
for Chevrolet Beretta 1988-1996
for Chevrolet C1500 1988-1996
for Chevrolet Camaro 1983-1995
for Chevrolet Cavalier 1983-1997
for Chevrolet Corsica 1987-1996
for Chevrolet El Camino 1985-1987
for Chevrolet Impala 2000-2004
for Chevrolet LLV 1988 1991 1993 1995
for Chevrolet Lumina 1990-1999
for Chevrolet Lumina APV 1991-1995
for Chevrolet Malibu 1997-2003
for Chevrolet Monte Carlo 1985-2004
for Chevrolet Tahoe 1995-1998
for Chevrolet Venture 1997-2004
for GMC Caballero 1985-1987
for GMC Jimmy 1987-1991
for GMC S15 Jimmy 1985-1991
for GMC Safari 1985-1994
for GMC Sonoma 1991-1997
for GMC Yukon 1992-1997
for Pontiac 6000 1983-1991
for Pontiac Aztek 2001-2003
for Pontiac Fiero 1984-1988
for Pontiac Firebird 1983-1997
for Pontiac Trans Sport 1990-1998
JPJEEP26
Reviewed in the United Kingdom on July 6, 2024
It fits well but I don't know if it works because my Jeep has a fuel issue and I'm just buying bits that are related incase it's that bit that's busted. I'll edit later on when it starts running.
cody
Reviewed in the United States on February 19, 2024
If you need a 1 bar map sensor than this is for you .
exiled350
Reviewed in the United States on January 6, 2024
This is a 1 BAR sensor not 3 BAR. The pigtail included is also not right for this application, so don't expect to use it with this sensor. Reads a little low, 4.55v at 101kpa with a regulated 4.95v supply, not doing science with it so whatever.
AdrianT
Reviewed in the United States on January 27, 2024
Why provide a harness that does not mate with the sensor? Cutouts in the Delphi type connector are in the wrong place to connect to the sensor. Completely useless as sent.
Taylor
Reviewed in the United States on June 28, 2021
This is not a replacement for Gm acDelco p#12223860 The 3bar map sensoryou are looking for. This sensor is a replacement for p#16137039 which is the 1 bar version. This will not read above atmosphere. Open to ambient air, at sea level it reads 4.98v which means it reads 1 bar at its max voltage. So do not buy this for your boosted applications.
Robin Kimble
Reviewed in the United States on December 28, 2021
Pigtail pins misaligned and wouldn't fit into sensor. What a drag
Markus Cartellieri
Reviewed in the United States on November 10, 2020
Does not work a it should
techa1883
Reviewed in the United States on October 8, 2020
Well for anyone that’ has a 1993 Chevy c1500 5.7 Tbi it’s not for you the harness connector will work Just get the wires in the right place. But no the truck will not idle. I tried to figure out the part # but that got me know where. They were cool enough to send me a replacement same thing no idle.
Recommended Products
$18.99
$ 9 .99 $9.99