Your cart is empty.
Your cart is empty.Product Description
Bottom Buckle Design
Inverted buckle design can snap the protective cover over the terminals firmly.
Cover
Reinforced cover attached with nylon nuts to prevent accidents and reduce the possibility of short circuits.
Copper Plate
The 3mm thickened copper bar can can support up to 150A continuous current, and withstand max 48V DC voltage supply.
304 Stainless Steel Stud & Nut
The washer design of 1/4" studs bus bar will contribute to a full contact between lugs and copper, makes the connection safer, more stable current.
Copper Lug
Aienxn copper lugs are made of high quality copper to prevent corrosion. They can be welded or crimped and are suitable for solid or stranded wires.
D. Corcoran
Reviewed in the United States on May 7, 2025
In case you missed it, you are trading one larger screw for two smaller screws compared to the equivalent blue sea device for a net gain of one terminal
SD Tom
Reviewed in the United States on May 7, 2025
This would be a very good terminal block IF you could access the rows of terminals without disconnecting the main (feed) wire. As it is designed, the main terminal connector has to be removed to take off the cover every time you want to connect or disconnect a wire to the block. The rubber boot covering the main terminal just sits on the terminal so it will just fall away from the terminal leaving it exposed if you mount it vertically or on an overhead panel. With these issues in mind, it is okay for use as a ground block. Pluses are the number of available terminals and that each terminal has a lock washer.
Dave
Reviewed in the United States on May 28, 2025
Very easy to install, works great, and the size of it makes it easy to install any place.
Paul
Reviewed in the United States on May 22, 2025
Nice Low Profile Protective Cover. That minimizes wire exposure. Once everything is installed its low profile cover makes sealing (silicone) easier than some other different types.
JS
Reviewed in the United States on April 7, 2025
Quality is a little sub par when compared to Blue Sea, but it is a product I will install. I bought this looking for a more compact/dense bus bar than Blue Sea sells, ideally with only a single large stud - the way this one comes is a good form factor. Quality wise specifically, the main stud is loose and is secured with a nut on the top, and then another nut on that stud actually secures your wire lug that feeds it. The plastic is a little cheap, screws are a little cheap, again, as compared to Blue Sea (which is a high-quality brand).
The Faub
Reviewed in the United States on April 5, 2025
Fair design but grounding points are WAY too small and also have fine threads so virtually impossible to not cross-thread.
D. Sweet
Reviewed in the United States on December 23, 2024
Metal all sainless steel
Douglas L Braun
Reviewed in the United States on December 15, 2024
The only downside was that the included crimp-on ring terminals were rather cheap. I have plenty of better ones, so I just tossed them.
Recommended Products