Your cart is empty.
Your cart is empty.Our MaxxHaul 80745 side marker LED Amber lights are designed for high visibility fo trailers, trucks, etc. They can also serve as replacement lights for our MaxxHaul 70205 trailer light kit. Approved by DOT, these lights are compatible with 12V systems and are designed for clearance purposes. Easy to install and durable for longer use.
john hill
Reviewed in the United States on January 16, 2025
Easy to install good and bright
Jeffrey L Dagenais
Reviewed in the United States on August 30, 2024
LEDs are so wonderful. I brought my trailer into the 21st Century.
Rafal
Reviewed in Canada on August 23, 2024
Direct replacement if y got the lightbulb versionBright lights 👍for this one !!!
Tony R.
Reviewed in the United States on July 22, 2024
Replaced broken one's for these. Look great once installed. Great product and price.
Mentalcolic
Reviewed in the United States on June 6, 2024
Like a fool I tried mowing too close to my trailer and hit my old light with the mower and broke it. These were the same size, so just two screws to remove the old one and this screwed back into the same holes. Two wires to connect which can be connected with twist on "wire nuts" or crimped into wire connectors. I just used twist-on wire nuts. 5 min. to replace. Bright LED so should last longer than the old incandescent, wire-filament type bulbs. Seem sturdy and look/work well. Good value and I have a spare in case I break another.
Gerald
Reviewed in the United States on November 15, 2024
Very happy with the lights.
jon
Reviewed in the United States on September 3, 2023
Works well and easily installed with included electrical connectors
Robert
Reviewed in Canada on June 2, 2021
Pulled my boat trailer into a post broke a marker , bought these to replace my F up. Seemed to be good quality and certainly good value
SumWell
Reviewed in Canada on July 13, 2020
Just popped two self tapping screws and attached the wires, got the job done quick and easy. This is a single LED light in the middle.
Derrick s
Reviewed in Canada on July 13, 2020
Bright LED marker lights. Used them on my boat trailer. Time will tell how they hold up with submersion. Plastic housing is then and not flexable. Cracked two when tightening up the screws. Hardware provided is junk. Suggest using decent self tapping screws.
byron
Reviewed in the United States on October 5, 2020
My old lights had burned out and oxidized. I found these on Amazon and decided to give them a try. Installed in less time it took to find the tools. My advice is to use stainless self tapping screws and drill them in. Be careful toover tighten as this may damage the light frame. Once the self tapping screw penetrates, gently tighten until it sets firmly against the lights frame. Took the trailer 900 miles and the lights worked well.
Rick E
Reviewed in the United States on October 5, 2019
Side lights work as described. The LED is bright yet there is no light diffusion therefore a single bright LED. The wire leads from the light come out from off-center therefore do not match holes in my frame for previous lights. I had to disassemble the light and drill new holes for the wire leads to exit the center and pass through the frame of my trailer. Be careful when screwing the fixture to your frame. The cheap black plastic breaks at the slightest pressure. All in all, this is a great value even with the necessary modifications and caution in mounting.
Customer
Reviewed in Canada on April 2, 2019
They worked and were easy to install. My old marker lights grounded through the mounting screw which was really unreliable and a major PITA. These are wired for individual grounding or a ground loop which is better.I drilled a little pilot hole in the frame and used a self tapping screw and a 'star' washer to attach the ground. Works great.
Recommended Products