Your cart is empty.
Your cart is empty.Mishimoto Fan Shroud Kit will considerably improve engine cooling functions and the overall performance of your vehicle. All mishimoto fan shrouds are significantly lighter than standard fan shrouds, and are a direct OEM fit. They will notably improve engine cooling performance by delivering more air to the radiator and driving out excess heat. Mishimoto fans shroud kits will safely secure the fan blades from potentially damaging other vital engine components.
Customer
Reviewed in the United States on July 27, 2022
Bolts right up! Fans work great with no overheating issues. I have no problem buying it again for another car.
Joe
Reviewed in the United States on December 7, 2022
fans kick ass but the shroud needed modifications to fit my koyo N-FLO Dual Pass S13/S14 V8 Swap rad
WH
Reviewed in the United States on August 10, 2021
Fits great with the matching mishimoto radiator.Unfortunately the install hardware and customer support leaves much to be desired.There was no install instructions even when emailing mishimoto directly.
Carlos
Reviewed in the United States on December 18, 2020
Good
Elisa Slade
Reviewed in the United States on October 26, 2020
The reason I bought a dual fan was to help cool the motor during a drift event. It kept it cool and this product definitely exceeding my expectations.
mr.chance
Reviewed in the United States on July 4, 2019
Works perfect!
Jettata
Reviewed in the United States on March 11, 2016
Fits perfectly, looks amazing, works even better. Superior quality and performance over OEM and other aftermarket manufacturers. Just wish it came with factory plug and had more useful hardware pack included.
Kouki~Monster
Reviewed in the United States on December 23, 2012
This shroud and fan combo is nicely built, looks good and frees up room plus a little HP. Fans are noticable when there switched on, and u can hear them from the inside of the car with the radio off. Granted there not as loud as the OEM clutch fan when its engaged and driving around my apt complex in 1st gear doing 10mph sounding like a idling C-130. My only problem is the lower mount tabs didnt line up completely, especially with the supplied hardware (tapered bolt, washers & nuts). The top tabs did just fine. i just had to get the proper hardware, which was 10mm bolts and nuts for the top and bottom. the bottom tabs where off center about 1/4" of what looked like a 1/2 hole on both the lower shroud tab and radiator mount holes. which allows for the smaller 10mm bolt i used along with two 5/8" finder washers to sandwich the tabs together. this minor hardware switch corrected the problem and holds the shroud firmly in place. the factory fan harness to the OEM electric fan can be used to run both these fans. the OEM 2 speed fan harness has 4 wires (2 gounds & one hi spd one lo spd) just wire the blacks to each of the black wires coming from the Mishimoto fans. and the other (white/red and brown/white) to the blue wires off the Mishimoto fans. the factory ECU will now kick on one fan (low speed) at 203 degrees and off at 194, and both at 212 then back to just one at 203.
Recommended Products
$90.00
$ 39 .99 $39.99