Your cart is empty.
Your cart is empty.Product Description
cdaleman81
Reviewed in the United States on August 8, 2024
It fits well and improved battery life over the old work out battery it replaced the but capacity doesn't seem to be equal to the OEM when it was new even though it's advertised to be the same as original.
Vee Aguirre
Reviewed in the United States on August 24, 2024
I love the packaging it came in and how neat and secure everything was!! Love it all!
Anonyshopper
Reviewed in the United States on July 8, 2024
Hi Folks,I bought this battery as a companion to my screen replacement since I already had the device opened up. (might as well, since I had it opened up). This item works wonderfully. The "snag" as it were was removing the original battery. They REALLY stick in there with the OEM double-sided tape!! Multiple folks have expressed frustration about the battery removal, so I wanted to give my own "trick" so to speak.!!!FIRE HAZARD!!!First you'll NEED a heatgun. Sorry, not optional if you want to avoid bending and risking tearing the old battery apart, setting everything on fire (remember: Li-ion batteries catch fire when opened up.) Hair dryer MIGHT work, but I'd expect it to take much, MUCH longer. Buy a heat gun.- Next, you'll want to find a thin, stiff BLUNT piece of METAL for the very first part. Think: butterknife, but most electronic repair kits contain a blunt metal spudger.- Next you'll just want to heat up the screen side for a few seconds (15-20) to warm up the tape's adhesive, and wiggle the spudger in just enough to get the bottom right corner up. You may bend the battery a bit, but if you're replacing it, no worries, as long as the packaging doesn't tear. TAKE IT SLOWLY!!!- Of CRITICAL importance, do not let the metal scrape the back of the case where the tape is applied. there's data ribbon cable there, and scratching that may destroy it.- Once the corner has a very slight gap, stick a PLASTIC spudger in, and stop using the metal one.- Next heat the screen side again, and alternate between heating and wiggling the plastic spudger in a little bit at a time. See: the plastic will continuously be wedged in there, applying a "lever" force against the battery. Heating up the adhesive will relieve some of that pressure, SLOWLY pulling the battery away from the tape.- heat, wiggle. heat, wiggle. heat, wiggle. Repeat until the battery peels out. --probably took me about half an hour (maybe more) of just heating and wiggling the spudger.The KEY is to keep pressure on that plastic spudger so that it constantly "pulls" the battery away from the tape. THIS TAKES A LONG TIME, so if you need to take a break, then come back to it later. remember: the risk you are taking is bending the battery so much it cracks and catches on fire. you do NOT want that!!! TAKE YOUR TIME.Hope this helps.Thanks!!
Jeffrey Taylor
Reviewed in the United States on July 16, 2024
Works great easy to install with easy to use instructions and the tools that came with it made it a brainer.
Willie
Reviewed in the United States on June 28, 2023
The product does not match the pictures.....And again I paid more because I wanted a different one.
old read fanatic
Reviewed in the United States on June 13, 2023
I liked the fast delivery. The battery has a longer life rating then the original. It was reasonably easy to install with the included kit of tools and adhesive. You will still require a small tube of sealant for application around the camera, fingerprint reader and around the circumference of the phone to make a water proof seal. Get one and add that to the purchase when you buy this kit.
Recommended Products