Shopping Cart

Your cart is empty.

Your cart is empty.

Modified Extended Longer Rear Fender FIt to Sur-Ron Light Bee X And S. Extra Long Dirt Pit Mudguards for SURRON.

4.8 (9) Write Review
Free shipping on orders over $29.99

$39.99

$ 20 .99 $20.99

In Stock

About this item

  • Powerful. When we ride on hills and soil, the original mini fender is not satisfactory, because it is too small to block most mud, especially during and after rainy days. Therefore, we developed a more helpful product "Longer Rear Fender".
  • Arm-Sized. As shown in the dimension drawing and comparison drawing on the left, LingQi modified extended rear fender is almost twice as long as the original fender.The extension of length helps to block mud and dust.
  • High-quality . Under the heating of 356 degrees Fahrenheit, 100% brand-new PP particles are melted and squeezed into the ferroalloy mold under the pressure of 50 Bar. The plastic atoms in the rear fender are tightly locked together without any air bubbles.
  • Convenient Installation. It needs to be installed between the seat cushion and the frame without fastening the hook like the original one. But don't worry that it will loosen. After tightening the screws, the iron sheet will connect them perfectly.
  • Marvellous Visual Feast. The extended rear fender is like a wolf's tail. The bike looks more linear, and the different design makes you the focus of friends when you go out for a ride with them.


Fit to Sur-Ron Light Bee X And S


Steve Spinks
Reviewed in the United States on March 4, 2025
Worked well for us
Mike Surron
Reviewed in Canada on February 26, 2023
I bought these for my surron x, the 2 main seat bolts fit with these, but after that the bottom seat protector will not fit exactly properly, I managed to get it to fit better with side fenders and it is much more secure now. Great quality plastic though, bends decently well. dont buy unless u arent prepared to play around with it for a while to get it to fit the way you want it
Jourdan A.
Reviewed in the United States on December 6, 2023
Product looks amazing and seems like great quality.Fender cracked after the second grade.
Donielle Irvin
Reviewed in the United States on August 30, 2022
No more soaking wet back/butt from the dew on my morning ride 👍Very pleased; it fit well on my 2022 Surron X.Don't cut the rivets on the side under the seat. You can pull them out by getting a putty knife under them (may need a couple taps with a hammer) and then you can reuse them for reassembly. The fender installs directly under the seat and its sandwiched in there.Grab a rubber mud sheild to keep your rear strut and motor cleaner while you're at it. Also a new set of pegs. Just a suggestion 👍
Jeffrey L. Cox
Reviewed in the United States on February 21, 2022
This is a great addition to X260, both front and rear stock fenders are too short, brittle & the 1st things I broke. 2nd photo is of the stock Segway rear fender attached to swing arm splash guard which protects tailight, & shock.
Andre Chotoosingh
Reviewed in the United States on April 6, 2022
The original guard was too stubby and I was still getting debris thrown on my back. I replaced it with this one and I’m pleased with the look and result. I think it’s a bit flimsy, but I see the point; it needs to be so it doesn’t crack easily. Although easy to install, look up a video (I found plenty) on how to install. I was about to install in under the bracket, which seems practical, but it actually goes on top. Minimal tools needed, done in less than 5 min, works great, happy with the upgrade.
Adrian
Reviewed in the United States on August 27, 2021
Better than stock fender but, for Segway X160, it should have slots to catch tabs under seat in addition to the two bolts for a total of 4 attachment points. It doesn’t so, just using the bolts now. Seems to work and looks good.
Andrey
Reviewed in the United States on August 10, 2021
Seems flexible enough.Important difference with the stock one is the way to install it:So for the stock one the order is: seat, frame, fender, plastic cover.For this one you need to do in following order: seat, fender, frame, plastic cover.In other words you need to install it on top (not bottom) of the metal frame under the plastic cover.
Jeff Saunders
Reviewed in the United States on July 30, 2021
Completely ignore the 1 star review. I own a Segway X260 and it’s super easy to install. The reason the other person failed was because the tried to install it just like the stock fender (under the sub frame). This product mounts below the seat and above the sub frame.Looks great. Just buy it.