Your cart is empty.
Your cart is empty.John Engelman
Reviewed in the United States on August 27, 2023
I purchased this to create a disconnect for the hotend on my ender 3 3d printer. This worked very well, and they give you one extra crimp for either end which is helpful. Definitely saved me!
Jerry L Phillippe
Reviewed in the United States on April 23, 2022
Purchased this connector but needed 12 pin DIP; ordered this one by mistake.
RICHARD M ROBLES
Reviewed in the United States on June 21, 2021
They are very small connections
Mike
Reviewed in the United States on December 6, 2018
Worked great! Make sure to buy a crimping tool too to make it look like a factory connection. I used this to repair a signal cable for some Bennett trim tabs. Saved a couple hours (trying to pull a new one) plus the $100 cable
Recommended Products
$12.97
$ 6 .99 $6.99