Your cart is empty.
Your cart is empty.Lifesanadventure
Reviewed in the United States on July 16, 2024
Looks great on my Mooer mini pedal board. Holds pedals tight in place, perfectly spaced, as well.
Grant E Gallagher
Reviewed in the United States on March 5, 2024
These don't really need a review. If you are looking at them you are probably familiar with Mooer and the expectations of quality are met here. These Z connectors really let you conserve space on your board with no compromise in signal. Highly recommend them and their straight ones to any pedal junkie.
Andy
Reviewed in Australia on March 14, 2024
I'm so confused by what they were going for with these.Pros: Less fiddly and messy than standard "pancake" patch leads for pedals close together.Cons: The shaft of the jack is SO LONG it sticks out nearly a whole centimeter from all pedals I tried them with. So it actually forces there to be MORE space between pedals than a patch cable with "pancake" soldered corners.A truly mystifying design choice. I ended up using it in a spot I didn't actually need to save space but had a micro tuner so small the rigidity of these held the pedal in place where Velcro wasn't going to work well.
M. B. Ekland
Reviewed in the United States on December 2, 2024
They're easy to use, and the space you save! I was using these 1/4"x 4" connector cables that just would not let me squeeze my pedals together the way these Z shaped connectors do. I want Mooer of 'em!!
Craig Yoder
Reviewed in the United States on February 6, 2023
Every other Z-connector didn't offset enough for the mini pedals, best way to connect the pedals and save space on a pedal board. Leaves the Mooer and Donner mini pedals in a nice, straight line.
Michael J
Reviewed in the United States on January 18, 2023
These are twice as expensive as the typical patch cord used to connect pedals, but they do allow you to get pedals closer together, and they should be more reliable, with no flexing cable to create noise or fail. On the other hand, that flex can be helpful in preventing the over-stressing of jacks if your pedals aren’t rigidly attached to a board, they only work with Mooer pedals or those having an identical configuration of jacks, and it looks like they could have gotten much tighter spacing. Time will tell.
Salo Rocas
Reviewed in Mexico on April 26, 2023
Exelente producto. No los pude encontrar en tiendas de música en la ciudad de México, así que me los mandaron del extranjero. Los tuve que comprar de la misma marca de mis pedales porque los que no son de la marca no quedan en el estuche de los pedales.
Joseph
Reviewed in Mexico on June 17, 2022
Conectores de excelente calidad.
Raul Lezama
Reviewed in Mexico on September 1, 2021
Son muy bonitos y compactos eso hace que te sobre un poco además de verse muy duraderos y elegantes
Valentine
Reviewed in the United States on December 15, 2021
Couldn't ask for a better guitar pedal connector, if you're not concerned about having your pedals farther apart from each other. This was definitely a must buy for me.
Kay D'nul
Reviewed in the United States on January 10, 2020
The off-set between the pins on these z-connectors is exactly as I expected to insure proper alignment of my Mooer pedals on my pedal board, but I was disappointed to find they cause unnecessary added space between my pedals due to a collar at the base of the pins. Not a problem if you’re not limited for space on your pedal board, not using a pedal board, or you have big feet and feel you benefit from more space between your pedals.
GV
Reviewed in the United States on February 4, 2019
Bought a bunch of these for the my Mooer M6 Firefly & Mooer PB-05 pedalboards. While they work fine in the pedalboards, they aren't very good while the pedals are on the floor. They're just way too unstable. You also need to remove most of the pedals (while cradled in the Firefly or PB-05) to exchange a pedal. That is why I went with the EBS 10 cm Flat cables. So much easier to exchange pedals now.
Recommended Products