Your cart is empty.
Your cart is empty.At Mopar, we're not just servicing cars-we're in service of people's lives. That's why we're committed to making owning your Chrysler, Dodge, Jeep, Ram or FIAT Brand vehicle the best experience possible, on and off the road.
Darcon
Reviewed in the United States on August 3, 2022
it fits my trucklike new . The dealership could notfimd but i did looks great
MICHELE
Reviewed in the United States on August 17, 2022
The rear clips have been redesigned (because that's what breaks). As a result, they DO NOT FIT! I couldn't even figure a way to alter it to make it work, so I returned for a refund.
Christine M. Greene
Reviewed in the United States on May 31, 2021
Super Easy to Install.
Francisco Navarrete
Reviewed in the United States on December 22, 2020
Great product easy to install
Martin Stallsmith
Reviewed in the United States on January 13, 2020
Fast shipping, easy install, looks like the original.
Marguerite Schuett
Reviewed in the United States on September 6, 2019
The console fit perfectly and makes the overhead look like new.
Jerry Derwin
Reviewed in the United States on April 30, 2018
Nothing to really say it is original fits great same quality as when I bought my truck it lasted for almost 14 years the first time so I should be good to go.
Customer
Reviewed in the United States on May 3, 2017
Seller rating gets a 5 star. DODGE RAM - MOPAR only gets 2 stars on this item due to a bit of a design flaw, in my opinion. There are two tiny tabs that the clear lens pivots on so you can turn the light on and off with a push of your finger. Those same little tabs hold the lens in place. The lens snaps in very firmly, to the point you think you're going to break something just trying to snap it in. It does not need to fit this tight. If it fit a little looser you wouldn't break the tabs off a couple of years down the road when your map light bulb burns out and you need to replace it. You shouldn't have to buy a whole new $150.00 part (as I had to do) just because a $3.00 light bulb burned out and needed to be replaced.Do yourself a favor. Take sand paper or emery board and file the tabs on the clear lens before snapping it into place. This will allow you to remove it without breaking it down the road when your light bulb needs replacing. I also changed my bulbs to LED (bulb number 578) because the factory bulbs get so insanely hot they make the plastic more brittle and more prone to breaking (like mine did). Hope this helps.
Recommended Products
