Your cart is empty.
Your cart is empty.Product Description
Jose R.
Reviewed in Mexico on February 21, 2024
Se usó en una ford lobo 2001 5.4l y quedó a la perfección
Charles Lusby
Reviewed in the United States on August 13, 2023
Installation went good, only issue I had was my bolts to the throttle body were too long for the new intake. I had some washers and used those.Overall it was a good deal.
Thomas Loudon
Reviewed in the United States on March 25, 2023
I installed this intake manifold due to mine leaking into spark plug hole #4 and causing a misfire. After installing this it now leaks even more and I now have 3 spark plugs getting wet. #4, #5, and #8. Intake manifold is leaking in multiple spots, most notably where the aluminum thermostat housing meets the plastic portion of the manifold. Tried contacting the manufacture as soon as this happened and received no response. This product is a straight rip off.
Wayne moore
Reviewed in the United States on April 8, 2023
I screwed all the screws into the holes before installing the intake to thread the holes first. The only issue I had was it was missing one of the smaller screws for the coils but I found one that worked in some of my junk parts. The intake is slightly different from the original Ford part but there was no fitment issues. So far it's working just fine. It is a big job to change and I hope It last a very long time. If there is any issues later I will update. Just remember to just snug the screws remember the intake is plastic don't over tighten them. I did remove the bolts to the cross over one at a time and applied some blue thread lock and snugged the bolts back up there is no metal inserts in the intake there so don't over tighten these bolts if you decide to do this or it could break the plastic intake.
Todd Ulrich
Reviewed in the United States on May 10, 2022
Fit was good. I would suggest not using bolts that are supplied as two broke off when putting them in.
Martins Steins
Reviewed in the United States on December 23, 2022
Works good for now
Lyndsey
Reviewed in the United States on August 16, 2021
Good product. Make sure you pre-screw the coil pack screws in before putting the intake in. You will save yourself a ton of time if you do so! Good luck on your project!
Joshua mcgouirk
Reviewed in the United States on December 30, 2021
The price compared to the auto store saved me about $120 bucks. Matched right up with the engine. Sealed and seated nicely. Only thing I did not use was the thermostat, I hot a no fell one instead.
Jason Barron
Reviewed in the United States on June 11, 2020
Works great! Sealed up nice and give me all my power back with zero leaks. Downside.... gasket is made into the manifold so if it ever goes bad you have to replace them both again.
Recommended Products