Your cart is empty.
Your cart is empty.Mr. Gasket - 9853 Alt Spacer 4X7/16 Univ
JOSEPH WIENERS
Reviewed in the United States on January 21, 2020
Worked perfectly
Minde
Reviewed in the United States on October 3, 2019
I'm sure the stupid thing is going to work out just fine but it would be great if you idiots would have delivered it to my house instead of forcing me to Chase all over town for two days looking for it
Tom
Reviewed in the United States on January 13, 2019
I bought a wind turbine generator.I cut to length this spacer for my turbine so it would tighten up solid.
Shane D.
Reviewed in the United States on September 3, 2016
Cut to fit. Just a hallow tube to cover a bolt and hold out bottom of alternator.
Shane
Reviewed in the United States on July 26, 2016
It's a crome tube
Léon M. C.
Reviewed in the United States on December 27, 2014
Used it to replace the old jury-rigged spacer that held the old alternator in place when I replaced it with a Hitachi 100-Amp on my 1978 Ford LTD. Having one of these that is properly sized is integral in engines with high-torque that may shift the alternator back and forth displacing the belts. This particular spacer fit perfectly for my application and did not require re-sizing.
OSB
Reviewed in the United States on October 23, 2014
What can I say, it worked exactly as it was expected to!
M. Mitchell
Reviewed in the United States on November 21, 2007
My old spacers had washers for adjustment. Bad idea. The alternator and fuel pump moved too much. Cut these to the actual length needed and they are ideal. Makes for a solid installation.
Recommended Products
