Your cart is empty.
Your cart is empty.Product Description
Why Choose TOPGRIL ?
1-Perfect Fit
We have a wide range of exclusive products for various car models, find the product you need and it will be a perfect fit for your car.
2-High Quality Material
The raw materials we use are strong and durable, greatly enhancing your experience.
3-Simple Installation
Our mud flaps kit not only can increase the appearance of your car's appearance value, but each product installation is also very simple, do not need to spend a lot of your time.
Installation Position Description / Please Install It In The Right Place
Impact Protective Construction - Withstands snow, dirt, sand, rocks, and other wheel-scattered debris due to its material-tough, impact-resistant thermoplastic construction
Upgraded Appearance - Bringing an instant improvement to your vehicle's appearance with a sleek look that looks like it came from the factory, your car will stand out from the crowd
Detail
Perfect Fit
Precise fit that matches the contours of your car perfectly.
Wide Enough Size
Built to the maximum width for more excellent protection of your vehicle.
No Drilling Is Required
Available for specific models for easy installation.
Suitable For Various Road Conditions
beemerguy03
Reviewed in the United States on March 5, 2025
they are to narrow to defect the wash thrown up by the tire so they do not help!
RICK
Reviewed in the United States on January 31, 2025
Fit good, slight trimming needed for right rear
RonnieB
Reviewed in the United Kingdom on June 14, 2024
One side went on fine but other side is not shaped to the underside of the car. Was able to cut out material to make it fit but was a bit fiddly. Got there in the end.
Demetrius 1905
Reviewed in Canada on May 5, 2024
On jeep compass scout. Had to trim one rear mudflap to fit. Added a 3rd screw in each as fastened to plastic.
Envio llegó rápido y exelente calidad 👍
Reviewed in the United States on December 16, 2024
Perfecto me encanto
Mark Walker
Reviewed in the United States on January 7, 2024
These were listed as fitting 2017- 2024 Jeep Compass models. I installed them on my wife's (new to her) 2019 Compass today. Had to do some significant retrofitting to get them attached. Only ONE of the two or three (depending on if front/back mudflap) holes pre-drilled in the flaps matched the existing fastener holes on the vehicle. The other two were at least 1/2" away from the existing fasteners, and no manipulation could get the holes in the flaps to line up with the factory fastener holes. Also, the instructions say to remove the existing screws, but on the 2019 Latitude version, there is only one removable screw, and the other fasteners are those plastic Fir Tree fasteners. If you remove them, the holes (IF they'd lined up) were far too large in diameter for the screws provided to hold the mud flaps in place. I wound up drilling new holes for the screws provided, and leaving the Fir Tree fasteners in place UNDER the flaps. Also, the original screw-out fasteners (threaded U-nuts/screw) were not the same thread as the screws provided, so on the single place on each I COULD use one of the originally positioned holes, I simply re-used the factory U-nut/screws. On the plus side, the mud flaps do perfectly match the contour of the Jeep's body, so once I retrofitted the attachment of them, they look fine.
lester millard
Reviewed in the United Kingdom on October 7, 2023
Highly recommended this make of mud flaps they fitted perfectly to the contour of the body, facing the front of the car back right front right front left all100%. Back left need a slight adjustment cutting a small bit of plastic off not to touch the inside of the plastic splash board under the arch, that’s all, for $52.00 great value they look great. Well know other makes at $152.00 each are simply over priced. Again to all those Jeep Compass owners 2017- 2024 they are perfect.
Sebastian
Reviewed in Canada on January 27, 2023
I have to trimmed to install the rear right hand mud flaps to make it fit on my 22 compass. By other hand good for the price
iaff170
Reviewed in the United States on January 19, 2023
I started installing these on the drivers side and they fit well. I then went to the passenger side. When I got the the rear, it did not fit. I had to cut a couple inches of the plastic off to make this fit into place.For $40, you'd think this would fit the vehicle without having to modify it!
franky
Reviewed in Canada on February 11, 2022
This arrived early, that was great, but box looked like they played football with it, you have to love customs and purolator and their lack of respect , the box inside said right on it made in china, wow, thought these were American made, anyway, basic instructions, and basic to install, unfortunately the right rear of my set of 4 would not fit, the bottom corner was shaped wrong and pushed the fender inner liner in so you could not get screw in it, had to actually cut the corner shorter and re arc it, the rears should also have an extra hole in it like the fronts, this would give it extra support .
Mgoodman
Reviewed in the United States on August 15, 2021
All but right side rear where easy to install and i used my original hardware. You will need to cut a little. It if the plastic off on the right side for it to fit flush. It does not take away from the appearance from the outside. The keep is not flat on the back but the mud guard is. I took a picture to show you. Just used a razor blade to cut it off. Very simple. Took 20 min to install all four guards. Would recommend.
KodiakTundra
Reviewed in the United States on January 27, 2021
First off I will start of by giving the product 5 stars. The description say it is not for the Jeep Compass Trailhawk specially for a 2021 model (not listed) but that did not prevent me from purchasing the product. It will work with a minor modification to the passenger side rear flaps if you dont want to spend $100+ for OEM/Mopar. You will just need to cut/trim off a small portion of the splash guard to have it sit flush to the wheel well. After that the other three splash guards went on with no problem. Color wise it is a little lighter than the rest of the black trim on my Compass. We will see how long it'll start fading in the Arizona heat. All in all I am satisfied with the fitment and quality for the amount I paid.
Don & Rachel Foley
Reviewed in the United States on September 2, 2020
These are very nice, and fit perfectly for the most part. The only one I had a little trouble with was the right rear one, due to the shape of the splash guard on the bottom. These flaps come with hardware, but it wasn't needed on my installation. On the front two, you remove two body clips using a knife or flat screwdriver blade (or a clip removal tool), and an 8mm bolt on the bottom. Then replace them going through the holes in the flaps and into the body. The rear ones have two 8mm bolts. (Note: The bottom tab hole on the flap isn't used on mine). Now, here is where I had a little trouble lining up the right rear flap going back on. So, I started the top hole first and mostly tightened it, and was able to catch the bottom hole after that. Tighten carefully and don't overtighten. You're done!
Recommended Products