Your cart is empty.
Your cart is empty.Product Description
Here’s the tip for perfect application:
1. Warm the dot in your hand to room temp or in the palm of your hand for a quick minute.
2. Facing one side down into your candle holder and the other side up.
3. Insert your candle to candlestick by pressing firmly and twisting into the wax dot in a circular motion,make sure they all well attached to the dot.
NOTE: The temperature will affect the wax dots adhesive level, please make sure to warm the wax dots until they are soft and liable.
Joan Wimmer
Reviewed in the United States on June 4, 2025
A fail - these do not hold the candles (any size) upright.
Lindapashopper
Reviewed in the United States on January 5, 2025
They fit exactly and don't show under the candles. They are a universal fit... holds candles straight and tight! Nice value!!
P. Suzanne Sloan
Reviewed in the United States on August 17, 2024
These are great and not bulky.
Arielle
Reviewed in the United States on May 2, 2024
They do the job. Not as sticky as I thought they would be - but they still work fine - keeps candles upright instead of falling over.
Claudine N.
Reviewed in the United States on March 7, 2024
These do not work . My candles are not straight. They wobble. I tried melting them a bit to make them pliable to put at bottom of my tapered candles and that didn’t work either. Terrible product that does NOT WORK.
Lush Currency
Reviewed in the United States on January 18, 2024
This was not even remotely pliable so I could not put it my candle holders to stabilize my candle. Gave it 3 stars since it is wax, albeit hard wax.
Liz C
Reviewed in the United States on December 26, 2023
These mostly work, I've had one candle/holder that just did not work with these, but everything else has done fine. The key is, the dots are hard unless you warm them up. All you have to do to warm them up is hold them in your hand for a minute or so, the warmth softens it up so you can get your candle placement. I like the different sizes, but I also think there should be a size smaller. I find I can break smaller of these in half to work for most of my candles that need the help standing up. Do check after a couple days in place, especially if you plan on lighting. One of my taper sets I have to reset the dots a bit, then put the tapers back in place so they melt evenly. It's like the dots harden back up again and stop being sticky. Works so far for my uses, it's just a little fussy.
Kathy Fischer
Reviewed in the United States on December 2, 2023
Easy to pull apart and place on candles to keep them standing straight. Thank you!
Recommended Products