Your cart is empty.
Your cart is empty.Product Description
STEP 1
Power off your phone. Remove the two Pentalobe screws, located at the bottom of the phone.
STEP 2
Use a Heat Gun or Hair Dryer, to apply mild heat to the lower edge of the phone about 1 minute
STEP 3
1.Install the suction cup in the lower left corner of the display assembly.
2.Pull up on the suction cup with firm to create a slight gap between the front panel and rear case.
3.Insert the crowbar into the gap and twist the spudger to widen the gap.
4.Slide the spudger up the side of the phone to separate the adhesive and free the clips.
STEP 4
Open the display. because the display assembly is still connected to the case on the left side of the phone, then don't open the display further than 90º, The Cable will break if stretched too far.
STEP 5
Remove Phillips screws securing from battery connector bracket and Removed.
STEP 6
Use the tip of the spudger to disconnect the battery connector from the logic board
STEP 7
1.Disconnect the front camera flex cable.
2.Disconnect the digitizer flex cable.
3.Disconnect the display cable
STEP 8
Remove the phillips screws fixed to the front panel sensor assembly connector from the bracket and remove the bracket
STEP 9
1.Disconnect the front panel sensor assembly connector from the logic board.
2.Remove the display assembly.
STEP 10
1.Remove the three Phillips screws securing the earpiece bracket to the front panel.
2.Remove the earpiece speaker bracket.
STEP 11
Lift the front facing camera out of the way to access the earpiece speaker.
STEP 12
Remove the following two Phillips screws securing the earpiece speaker to the front panel.
STEP 13
Remove the earpiece speaker.
STEP 14
Use a spudger to gently pry the ambient light sensor out of its recess on the front panel.
STEP 15
1.Use a spudger to gently pry the ambient light sensor out of its recess on the front panel.
2.Use the pick to lift the front camera cable up off of the two plastic posts on the front panel and separate it from the last of the adhesive.
STEP 16
Remove the front camera and sensor cable.
BohemianMermaidSoul
Reviewed in the United States on March 6, 2023
Husband did not read all the fine print. This is for an iPhone 8 PLUS, does NOT work for iphone 8.
Smilee
Reviewed in the United States on November 16, 2022
I normally don’t write reviews but I ordered two other flex cables from other companies and the first one the speaker stop working with one and the second one the camera was like a fish eye . But this one works great . If you need it . Don’t second guess . Get it!!!!!. I am overly happy that my phone is fully functioning
Shenneka P
Reviewed in the United States on June 8, 2019
The fact you have to fold the camera and position it right to work
Lee
Reviewed in the United States on June 22, 2019
Replaced it with the original and it works.
Customer
Reviewed in the United States on June 21, 2019
Easy to install, would recommend anyone replacing a cracked screen to purchase this at the same time, because the ribbon is almost always damaged, so don’t replace a screen without the ribbon or you are probably doing it twice
AMber shephard
Reviewed in the United States on July 26, 2018
It was shipped quickly and quality was great
Recommended Products
$23.95
$ 11 .99 $11.99