Your cart is empty.
Your cart is empty.NGK Y-114T (6528) SPARK PLUG
Coffee Lover
Reviewed in Canada on May 22, 2024
Best price available for this NGK replacement for original Champion 144 glow plugs
Karl Baumann
Reviewed in Germany on November 25, 2024
Eingebaut-passt- geht „Einwandfrei“ !!
JT
Reviewed in the United States on October 22, 2024
Price is right. Works on my diesel tractor. Happy with the purchase
dc-in-md
Reviewed in the United States on April 15, 2023
Fantastic glow plugs. Exactly what I needed. After some troubleshooting I determined that the 3 glow plugs were getting power but were not heating up. I was terrified removing the original glow plugs. They were tight and stuck well. I spent about a week heat cycling the engine and treating the glow plugs with PB Blaster. I could get 2 of the 3 out easily but that 3rd one was a challenge. I finely used my air ratchet and it popped loose. As I backed them out , if they showed signs of sticking I would respray with PB and tighten the plug back down a turn or two. Slow and steady wins the unbroken glow plug award. I tested each one before installing and used anti-seeze to help with next time. Now my Case 235 easily when cold 😆. I was suprised that the glow plug indicator coil started to work after I replaced the glow plugs.
Laszlo Gaspar
Reviewed in the United States on July 18, 2022
I ordered 3 and was sent two. Out of the two one was missing the washer.
José
Reviewed in Spain on March 19, 2022
UTILIZADO EN UN SAME 55 CON MOTOR MITSUBHISI
berrypatch101
Reviewed in the United States on September 23, 2021
Worked like it is supposed to.
Customer
Reviewed in Canada on May 8, 2020
remplace très bien c eux d origine sur mon mahindra 2216 merci
EBGwd
Reviewed in the United States on October 28, 2020
I have Satoh Beaver III, (S-373D) with the Mitsubishi 3-cylinder engine (K3A-12BE).Glow plugs are original from 1983 and came out easy after spraying and soaking with WD-40 and PB-Blaster.New glow plugs worked great and fit perfectly. Ready for winter!
ふみゃりん
Reviewed in Japan on January 5, 2020
農業機械は持っていますが、グロープラグを個人で購入するのは初です。約30年前の除雪機を購入してメンテをしてましたら、大抵のパーツはまだ出回ってますので、エンジンが壊れない限り使えるのです。製造メーカーに問い合わせれば 代替え品も教えてくれるので 古くてもパーツに苦労する部分は少ないと思ってました。エンジンの物理的な破損以外は修理可能ですが、プラグだけは手こずりました。30年前の機体なのでプラグが製造中止になっていました。そこで全プラグを外したら一部に今でも製造している型番があったものの、在庫無しで 製造に2週間待ってください。実際取り出したプラグをデジタルノギスで寸法を測ると色々と見えてくる。要は型番が違っても 直径・中に入る寸法・定格電圧等一致してれば 代替え品として使えるようです。
Kai S.
Reviewed in the United States on April 24, 2020
This product is an exact match for the TYM 293 with a 3 cylinder mitsubishi engine, at least it fits the 2012 model year. The description size is not correct they are 3 1/4" long, not 5.5 as stated. Otherwise these work great.
CP
Reviewed in the United States on February 19, 2014
We bought these for a older tractor. We installed them and they blew themselves out. We had to purchase other ones to replace.
Delmas Maxey
Reviewed in the United States on September 22, 2013
Makes my tractor run like it should. Would purchase this item again. Thank you again and again and again. God Bless
Recommended Products
