Your cart is empty.
Your cart is empty.Rodger Earll
Reviewed in the United States on March 16, 2025
Works as it should
Yanbu92
Reviewed in the United States on March 3, 2024
Doesn’t fit AR very well. Lower block falls out, too small. Upper is too small, leaves gap when clamped, thus loose when clamped.
Ed NEAL
Reviewed in the United States on December 14, 2024
It worked perfectly just what I needed for my repair.
Customer
Reviewed in the United States on April 13, 2024
It worked well when I used it.
William Yelder
Reviewed in the United States on June 21, 2023
Good tool
T. Wright
Reviewed in the United States on December 12, 2023
As the title states. Not quite the perfect shape. I don’t know how you screw that up. But it will still hold the receiver well enough to torque down a barrel.The part that goes into the magazine well is also very sloppy loose. But it holds the receiver upright. A block of wood roughly cut to the shape of a magazine would probably work just as well, lol.
Jeanetta
Reviewed in the United States on November 14, 2023
Does not fit mill spec upper, broke in vise during first use, not 1 but 2 the replacement I received was the same garbage and broke as well. Doesn’t fit and doesn’t work, spend a few extra bucks for something better that will work.
Thee Buzzard
Reviewed in the United States on April 6, 2023
The upper vice block does NOT fit any standard AR upper. The lower block fits the mag well, but does not lock into the mag release.Copy paste review but it's true same same for me.
Recommended Products
