Your cart is empty.
Your cart is empty.Product Description
This is an OEM repair part
Exact same Fit, Form, and Function
Yet Another Project
Reviewed in the United States on February 14, 2025
Factory part, easy to change out. Less than 1hr job.Get crimping pliers for the hose clamp. $15-20Also replace the rubber seal while everything is apart. $20
Kevin J. Peterson
Reviewed in the United States on September 7, 2024
My KitchenAid dishwasher would still run but after filling with water at the beginning of a cycle it wouldn't do anything. Wouldnt spray water around at all, then drain and repeat. The dishwasher pod would be wet but not dissolved in the bottom of the tub.. Internet searches of these symptoms quickly determined it was a bad circulation pump. Ordered this one and it arrived next day. I installed it within minutes of receiving it. The install is a little involved but easily doable by following YouTube videos. I'm not an expert by any means but theres not a lot to a dishwasher. Took me about two hours from beginning (turning off the breaker) to end (dishwasher back in cabinet and leveled and mounted) but the washer is back up and running like new. Very happy spending $90 and a little time to fix our 5 year old dishwasher that otherwise is in like new condition. Service call with part would have probably been around $500-$600. I've only ran a few loads this last week but so far so good.
ParrotPilot
Reviewed in the United States on August 18, 2024
No need to buy special pliers to attach the OEM hose clamp. This pump comes with a standard hose clamp that can be attached with a screwdriver. Perfect fit for my dishwasher and it works great.
Chris J.
Reviewed in the United States on February 26, 2024
Drop in replacement for KitchenAid St. Steel flush mount dishwasher. Bonus: it comes with a regular (screw type) clamp in case you don't have the required pinch-clamp tool.
Eddie Vedder
Reviewed in the United States on October 12, 2024
Water sat in bottom and didn't circulate, also had error code indicating pump. Pump fit, worked, and included a standard hose clamp. Hopefully it lasts.
Triple Aries
Reviewed in the United States on April 19, 2024
I watched a video on YouTube how to swap out the old part and install this new one and it worked great. I recommend gettingW10195677 WPW10195677 Dishwasher Diverter Valve Diverter Motor Seal Grommet Gasket Compatible with Whirlpool too bc during the process, you remove a part that loosens this tiny gasket which then causes another leaking problem. Just purchase this too and swap it out proactively.
Jacynthe
Reviewed in Canada on September 9, 2023
Installing the pump was extremely easing following the video. So happy we bought this instead of the « official » whirlpool part that was 350$!!
rrgribs
Reviewed in Canada on June 9, 2023
Our four year old KitchenAid dishwasher suddenly stopped working. I determined it was the circulation pump and decided to replace it myself. Everywhere wanted over $300 for it. I found it on Amazon for half that price. I was skeptical at first as I've never ordered parts from Amazon but it showed up in less than a week and was exactly what I needed. The pump even came with an adjustable hose clamp in case you didn't have a crimper for the crimp clamp that comes on the pump. Installed in under 15 minutes and the dishwasher is working again. If you need a circulation pump, get this and save yourself the money.
Upside Down
Reviewed in the United States on October 30, 2023
My 3 and a half year old Whirlpool WDT750SAHZ0 stopped spraying water. It drained so i knew that Input valve and drain pump were working so it looked like the wash pump was bad. Checked resistance and it read 8.5 ohms which was actually correct. Control board had two fuses and they were both fine. Ordered a new pump anyway and it worked. Easy to install after looking at YT videos of course. Physically, the motor seems undersized for all the work that it does but Whirlpool knows best right? Gotta keep those appliance techs busy I guess. Don't know about longevity but the new pump looked well built.
IntegrityTeks
Reviewed in Canada on October 22, 2023
Self installation saved me over $250 in service call feesYouTube is your friend😀😀😀
Wilson! I'm sorry Wilson!
Reviewed in Canada on January 30, 2023
Absolutely perfect, and the price is amazing considering my local appliance repair shop wanted $350 for this part.So this was a match for my Whirlpool WDTA50SAHW0 - classic symptoms were the cycle completing normally (filling and draining) but the water was simply sitting at the bottom and not circulating. The repair was quite easy - I found I did not need to remove the rectangular white thingy as shown in the video, there seemed to be more than enough room to get the old circulating pump out and install the new one. You'll need a little patience getting the hose in the correct position, but I managed it with 5 minutes of fiddling.The replacement pump also ships with a plain hose clamp (in addition to a crimp ring) for those of us who don't have a crimp tool. This made securing the hose on the new pump really easy.
Eileen
Reviewed in Canada on May 9, 2022
Disliked the fact that the part was broken in delivery box, we glued it and are hoping that it holds together. The part was used in dishwasher.
Mathew B.
Reviewed in the United States on December 29, 2022
I ordered and installed this part in early October and it worked great, but failed in late December. I'm trying to get a hold of the company for warranty information and to get a new one but cannot find any contact information so I'm hoping they see this review and reach out.
Recommended Products