Your cart is empty.
Your cart is empty.Omix proudly offers a vast collection of OE quality replacement parts for Jeep & Willys vehicles to help keep the Jeep legend alive. This replacement front spindle nut / washer kit fits 41-45 MB / GPW models. Kit includes 2 nuts and 2 washers. For individual nut, use 16710.03. Replaces OE A867K
mariano carlos ledo
Reviewed in the United States on November 3, 2023
Justo lo q buscaba. Excelente calidad
tim Fowler
Reviewed in the United States on October 12, 2023
Fits
BC
Reviewed in the United States on March 19, 2022
These worked perfectly, the threads and washers fit perfectly, installed with new wheel bearings and had zero issues.
travels
Reviewed in the United States on March 12, 2022
Nuts are black coated. Washers are thinner than originals but work just fine.
fit12
Reviewed in the United States on April 3, 2021
Perfect replacement for those nuts that have been removed with an incorrect tool. Buy the socket! It’s not going to break the bank and they need to be torqued to 50 ft pounds!!!
Tinker000
Reviewed in the United States on July 21, 2019
I purchased two kits, one nut in each kit had a portion sliced off one of the faces. Like it was previously installed and someone had used a chisel instead of a socket to remove it. Of the two kits I was able to make one good one. I am going to reuse both inner old ones instead of taking a chance on another being bad. The outer edges (corners) of the nuts also had a very sharp edge that had to be filed off in order for the socket to fit squarely. The larger washer tabs also needed filing to fit the slot in the new Crown spindles I purchased. I think these parts should have gone through an abrasive tumbler to knock the edges down before sales. I won't purchase them from OMIX-ADA again. The nut hex sides also are slightly off center from the threaded area.
susan west
Reviewed in Canada on December 13, 2019
a bit rough but worked fine.
Boss
Reviewed in the United States on November 7, 2019
Perfect replacement parts for 4WD hub on my 1962 Willys Utility Station Wagon with Dana 27 axle.6 cylinder 230 cubic inch OHC engine. Also bought Omix-Ada 16711.01 Spindle Nut Socket which fits perfectly - even though the Amazon parts finder shows it won’t fit this vehicle, it does.
Zachary S Roberts
Reviewed in the United States on January 12, 2018
I used these for bearing and spindle work on a 1983 Jeep CJ-5. These parts are very well made and were purchased to replace nuts that had been mangled by a previous "mechanic" using a chisel. Would purchase these again if needed.
Recommended Products
$15.25
$ 6 .99 $6.99
$31.97
$ 15 .99 $15.99